AT25DF321A-SH-B Atmel, AT25DF321A-SH-B Datasheet - Page 40

• Manufacturer Part Number: AT25DF321A-SH-B
• Description: IC FLASH 32MBIT 100MHZ 8SOIC
• Manufacturer: Atmel

Specifications of AT25DF321A-SH-B

• Format - Memory: FLASH
• Memory Type: DataFLASH
• Memory Size: 32M (16384 pages x 256 Bytes)
• Speed: 100MHz
• Interface: SPI, RapidS
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (5.3mm Width), 8-SOP, 8-SOEIAJ
• Memory Configuration: 16384 Pages X 256 Bytes
• Interface Type: Serial, SPI
• Clock Frequency: 100MHz
• Supply Voltage Range: 2.7V To 3.6V
• Memory Case Style: SOIC
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

12.5
Hold
The HOLD pin is used to pause the serial communication with the device without having to stop or reset the clock
sequence. The Hold mode, however, does not have an affect on any internally self-timed operations such as a program or
erase cycle. Therefore, if an erase cycle is in progress, asserting the HOLD pin will not pause the operation, and the erase
cycle will continue until it is finished.
The Hold mode can only be entered while the CS pin is asserted. The Hold mode is activated simply by asserting the HOLD
pin during the SCK low pulse. If the HOLD pin is asserted during the SCK high pulse, then the Hold mode won’t be started
until the beginning of the next SCK low pulse. The device will remain in the Hold mode as long as the HOLD pin and CS pin
are asserted.
While in the Hold mode, the SO pin will be in a high-impedance state. In addition, both the SI pin and the SCK pin will be
ignored. The WP pin, however, can still be asserted or deasserted while in the Hold mode.
To end the Hold mode and resume serial communication, the HOLD pin must be deasserted during the SCK low pulse. If
the HOLD pin is deasserted during the SCK high pulse, then the Hold mode won’t end until the beginning of the next SCK
low pulse.
If the CS pin is deasserted while the HOLD pin is still asserted, then any operation that may have been started will be
aborted, and the device will reset the WEL bit in the Status Register back to the logical “0” state.
Figure 12-5. Hold Mode
CS
SCK
HOLD
Hold
Hold
Hold
Atmel AT25DF321A
40
3686D–DFLASH–12/09