IRS26310DJPBF International Rectifier, IRS26310DJPBF Datasheet - Page 16

• Manufacturer Part Number: IRS26310DJPBF
• Description: IC DRIVER BRIDGE 3-PHASE 44-PLCC
• Manufacturer: International Rectifier

Specifications of IRS26310DJPBF

• Configuration: 3 Phase Bridge
• Input Type: Non-Inverting
• Delay Time: 530ns
• Current - Peak: 200mA
• Number Of Configurations: 1
• Number Of Outputs: 3
• High Side Voltage - Max (bootstrap): 600V
• Voltage - Supply: 12 V ~ 20 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 44-PLCC (32 Leads)
• Peak Output Current: 200mA
• Input Delay: 530ns
• Output Delay: 530ns
• Supply Voltage Range: 12V To 20V
• Driver Case Style: LCC
• No. Of Pins: 44
• Operating Temperature Range: -40°C To +125°C
• Rohs Compliant: Yes
• Device Type: High Side / Low Side
• Family Hvic: General Purpose HVICs
• Channels: 6
• Topology: Three Phase
• Application: General Purpose / Motor Control / PDP
• Voffset: 600
• Io+ (ma): 200
• Io- (ma): 350
• Shutdown / Reset: Yes
• Separate Power And Logic Ground: Yes
• Integrated Bootstrap Diode: Yes
• Over Current Protection: Yes
• Uvlo: Vcc / Vbs
• Vbsuv+ / Vccuv+ Min (v): 10.4
• Vbsuv+ / Vccuv+ Typ (v): 11.1
• Vbsuv+ / Vccuv+ Max (v): 11.6
• Vbsuv- / Vccuv- Min (v): 10.2
• Vbsuv- / Vccuv- Typ (v): 10.9
• Dt / Sdt Min (ns): 190
• Dt / Sdt Typ (ns): 290
• Dt / Sdt Max (ns): 420
• T On Min (ns): 400
• T On Typ (ns): 530
• T On Max (ns): 750
• T Off Min (ns): 400
• T Off Typ (ns): 530
• T Off Max (ns): 750
• Fault Reporting: Yes
• Package: 44 Lead
• Part Status: Active & Preferred
• Special Features: DC Bus Sensing with Over Voltage Protection
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

IRS26310DJPbF
Switching and Timing Relationships
The relationship between the input and output signals of the IRS26310D is illustrated below in Figures 3. From this
figure, we can see the definitions of several timing parameters (i.e., PW
, PW
, t
, t
, t
, and t
) associated with
IN
OUT
ON
OFF
R
F
this device.
Figure 3: Switching time waveforms
The following two figures illustrate the timing relationships of some of the functionality of the IRS26310D; this
functionality is described in further detail later in this document.
During interval A of Figure 4, the HVIC has received the command to turn-on both the high- and low-side switches at
the same time; as a result, the shoot-through protection of the HVIC has prevented this condition and both the high-
and low-side output are held in the off state.
Interval B of Figures 4 and 5 shows that the signal on the ITRIP input pin has gone from a low to a high state; as a
result, all of the gate drive outputs have been disabled (i.e., see that HOx has returned to the low state; LOx is also
held low), the voltage on the RCIN pin has been pulled to 0 V, and a fault is reported by the FAULT output
transitioning to the low state. Once the ITRIP input has returned to the low state, the output will remain disabled and
the fault condition reported until the voltage on the RCIN pin charges up to V
(see interval C in Figure 6); the
RCIN,TH
charging characteristics are dictated by the RC network attached to the RCIN pin.
During intervals D and E of Figure 4, we can see that the enable (EN) pin has been pulled low (as is the case when
the driver IC has received a command from the control IC to shutdown); this results in the outputs (HOx and LOx)
being held in the low state until the enable pin is pulled high.
www.irf.com
© 2008 International Rectifier
16