28029 Parallax Inc, 28029 Datasheet - Page 66

KIT PARTS SMART SENSORS W/TEXT

28029

Manufacturer Part Number
28029
Description
KIT PARTS SMART SENSORS W/TEXT
Manufacturer
Parallax Inc
Datasheet

Specifications of 28029

Accessory Type
Parts Kit
Product
Microcontroller Accessories
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
For Use With/related Products
BASIC Stamp® or Javelin Modules
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
Other names
28029PAR
Page 54 · Smart Sensors and Applications
All other BASIC Stamp Educational Boards
This section is for connecting the Ping))) sensor and Parallax Serial LCD to one of the
following BASIC Stamp educational boards:
Connect the other end of the cable so that the black wire is connected to the
Ping))) module's GND pin, the red wire is connected to the 5 V pin, and the
white wire is connected to the RX pin.
Double-check all your connections, including your jumper setting, and make
sure they are correct.
Plug the power back into the board.
Set the 3-position switch on the Board of Education to 2.
If you have a Board of Education Rev C, Skip to LCD Distance Display on
page 57.
BASIC Stamp HomeWork Board
Board of Education Rev A (Serial version)
Board of Education Rev B (Serial version)
Disconnect power from your board.
Build the breadboard connections as shown in Figure 2-10.
WARNING!
connections are correct.
Parallax Serial LCD could be permanently damaged.
You can also connect the Parallax Serial LCD to Port 14 with a cable. The instructions
are about the same as connecting the Ping))). Start by disconnecting power to your board.
The jumper for Vdd and Vin between the servo ports has to be set to Vdd. The cable has to
be plugged into the X4 header so that the black wire is closest to the X4 label and the white
wire is closest to the 14 label. When connecting the other end of the cable to the Parallax
Serial LCD, make sure the black wire connects to GND, the red wire to 5V, and the white
wire to RX.
Do not connect power to your board until you are positive the
If you make a mistake with the LCD connections, the

Related parts for 28029