DEMOBOARD TLE 6244X Infineon Technologies, DEMOBOARD TLE 6244X Datasheet - Page 21

• Manufacturer Part Number: DEMOBOARD TLE 6244X
• Description: BOARD DEMO FOR TLE 6244X
• Manufacturer: Infineon Technologies

Specifications of DEMOBOARD TLE 6244X

• Main Purpose: Power Management, Low Side Driver (Internal FET)
• Embedded: No
• Utilized Ic / Part: TLE6244
• Primary Attributes: 18 Channel Internal Switch
• Secondary Attributes: Overvoltage, Short-Circuit & Thermal Protection
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: DEMOBOARDTLE6244XIN

Final Data Sheet
Reading the IC Identifier (SPI Instruction: RD_IDENT1):
Reading the IC revision number (SPI Instruction: RD_IDENT2):
Reset of the Diagnostic Information (SPI Instruction: DEL_DIA):
Resets the 5 diagnostic registers DIA_REG1...5 to FFH and the common overtemperature flag in regis-
ter STATCON_REG (Bit4) to High. These bits are only cleared by the DEL_DIA instruction when there
is no failure entry at the input of the registers.
Access is performed like a writing access with any data byte.
In the case a power stage is shut off because of SCB, the output is activated again by the DEL_DIA
instruction and the filtering-time is enabled. Therefore in case of SCB the output is activated and shut
off after the shutoff delay.
For a power stage in the current limitation mode, the current limitation mode is left, if a DEL_DIA
instruction has been received. If there is still the condition for SCB the current limitation mode
is entered again.
On the following pages the conditions for set and reset of the SCB report in DIA_REGx is shown in
several schematics. The signal „power stage control“ is generated as follows:
1.6.4 Other
IC Identifier1 (Device ID)
SWR3
Bit
7...0
IC revision number
Bit
7...4
3...0
ID7
7
7
INi=“ON“
SPI=“ON“
µsec=“ON“
Name
ID(7...0)
Name
SWR(3...0)
MSR(3...0)
SWR2
ID6
6
6
OR
SWR1
ID5
5
5
ABE not active
SWR0
Description
ID-No.: 10101000
Description
Revision corresponding to Software release: 0
Revision corresponding to Maskset: 0
ID4
4
4
AND
21
MSR3
ID3
3
3
power stage control = „ON“
MSR2
ID2
2
2
MSR1
Hex
ID1
1
1
TLE 6244X
V4.2, 2003-08-29
Hex
MSR0
ID0
0
0