CDB5345 Cirrus Logic Inc, CDB5345 Datasheet - Page 37

• Manufacturer Part Number: CDB5345
• Description: EVALUATION BOARD FOR CS5345
• Manufacturer: Cirrus Logic Inc

Specifications of CDB5345

• Number Of Adc's: 2
• Number Of Bits: 24
• Sampling Rate (per Second): 192k
• Data Interface: Serial
• Inputs Per Adc: 6 Single Ended
• Power (typ) @ Conditions: 400mW @ 5 V
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -10°C ~ 70°C
• Utilized Ic / Part: CS5345
• Description/function: Audio A/D
• Operating Supply Voltage: 5 V
• Product: Audio Modules
• For Use With/related Products: CS5345
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 598-1780

DS658F2
7. PARAMETER DEFINITIONS
Dynamic Range
Total Harmonic Distortion + Noise
Frequency Response
Interchannel Isolation
Interchannel Gain Mismatch
Gain Drift
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth. Dynamic Range is a signal-to-noise ratio measurement over the specified bandwidth made with
a -60 dBFS signal. 60 dB is added to resulting measurement to refer the measurement to full scale. This
technique ensures that the distortion components are below the noise level and do not affect the measure-
ment. This measurement technique has been accepted by the Audio Engineering Society, AES17-1991,
and the Electronic Industries Association of Japan, EIAJ CP-307. Expressed in decibels.
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels. Measured
at -1 and -20 dBFS as suggested in AES17-1991 Annex A.
A measure of the amplitude response variation from 10 Hz to 20 kHz relative to the amplitude response at
1 kHz. Units in decibels.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with no signal to the input under test and a full-scale signal applied to the other channel. Units in deci-
bels.
The gain difference between left and right channels. Units in decibels.
The change in gain value with temperature. Units in ppm/°C.
CS5345
37