STEVAL-ILL027V1 STMicroelectronics, STEVAL-ILL027V1 Datasheet - Page 17

• Manufacturer Part Number: STEVAL-ILL027V1
• Description: BOARD EVAL LED DRIVER FOR L6562A
• Manufacturer: STMicroelectronics

Specifications of STEVAL-ILL027V1

• Design Resources: STEVAL-ILL027V1 Schematics STEVAL-ILL027V1 BOM STEVAL-ILL027V1 Gerber Files
• Current - Output / Channel: 260mA
• Outputs And Type: 1, Non-Isolated
• Voltage - Output: 70V
• Features: Short-Circuit Protection
• Voltage - Input: 120VAC
• Utilized Ic / Part: L6562A
• Product: Display Modules
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• Other names: 497-10170

L6562A
7.5
Comparison between the L6562A and the L6562
The L6562A is not a direct drop-in replacement of the L6562, even if both have the same
pin-out. One function (Disable) has been relocated.
Table 2 compares the two devices, i.e. those parameters that may result in different values
of the external components. The parameters that have the most significant impact on the
design, i.e. that definitely require external component changes when converting an L6562-
based design to the L6562A, are highlighted in bold.
Table 6. L6562A vs. L6562
1. Function located on pin 5 (ZCD)
2. Function located on pin 1 (INV)
The lower value (-36%) for the clamp level of the current sense reference voltage allows the
use of a lower sense resistor for the same peak current, with a proportional reduction of the
associated power dissipation. Essentially, the advantage is the reduction of the power
dissipated in a single point (hotspot), which is a considerable benefit in applications where
heat removal is critical, e.g. in adapters enclosed in a sealed plastic case. The lower value
for the Dynamic OVP triggering current allows the use of a higher resistance value (+48%)
for the upper resistor of the divider sensing the output voltage of the PFC stage (keeping the
same overvoltage level) with no significant increase of noise sensitivity. This reduction goes
in favor of standby consumption in applications required to comply with energy saving
regulations.
IC turn-on & turn-off thresholds (typ.)
Turn-off threshold spread (max.)
IC consumption before start-up (max.)
Multiplier gain (typ.)
Current sense reference clamp (typ.)
Current sense propagation delay (delay-to-output) (typ.)
Dynamic OVP triggering current (typ.)
ZCD arm/trigger/clamp thresholds (typ.)
Enable threshold (typ.)
Gate-driver internal drop (max.)
Leading-edge blanking on current sense
Reference voltage accuracy ( overall)
Parameter
2.1/1.4/0.7 V
12/9.5 V
0.3 V
200 ns
L6562
±0.8 V
40 uA
70 uA
1.7 V
2.6 V
2.4%
0.6
No
(1)
Application information
1.4/0.7/0 V
12.5/10 V
0.45 V
L6562A
±0.5 V
175 ns
1.08 V
27 uA
60 uA
2.2 V
1.8%
0.38
Yes
(2)
17/26