ATAVRQTOUCHX Atmel, ATAVRQTOUCHX Datasheet - Page 65

• Manufacturer Part Number: ATAVRQTOUCHX
• Description: BOARD EVAL CAPACITIVE TOUCH
• Manufacturer: Atmel
• Series: QTouch™r

Specifications of ATAVRQTOUCHX

• Sensor Type: Touch, Capacitive
• Sensing Range: 1 Slider, 1 Wheel, 2 Buttons
• Interface: USB
• Voltage - Supply: 5V, USB
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: AT90USB1287, ATxmega128A1
• Silicon Manufacturer: Atmel
• Silicon Family Name: ATxmega
• Kit Contents: Board
• Svhc: No SVHC (15-Dec-2010)
• Core Architecture: AVR
• Core Sub-architecture: AVR19
• Kit Features: One Slider, One Wheel And 2
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Sensitivity: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

SNS1 – SNSK1 & SNS2 –
SNSK2
QT_NUM_CHANNELS
_ROTOR_SLIDER_
_DEBUG_INTERFACE_
QT_DELAY_CYCLES
QTOUCH_STUDIO_MASKS
_STATIC_PORT_PIN_CONF_
Figure 5-15 : Specifying the QTouch acquisition method library configuration parameters
Section 5.7.1.5.2 has
details on the range of
values allowed
4, 8, 12, 16 for tinyAVR,
megaAVR and XMEGA
device libraries and 8, 16,
32 for UC3 device libraries.
Rotor / slider can be added
to the design, if this symbol
is defined
The debug interface code in
the example application will
be enabled if this macro is
enabled.
1 to 255
This macro needs to be
defined if QTouch Studio
Pin Configurator Wizard.is
used to generate the SNS
and SNSK masks.
This macro needs to be
defined only in case of 4
and 8 channel libraries with
interport configuration and
pin configurability.
in AVR Studio IDE
To be used if two port pairs are needed for
the design
A library with rotor / slider functionality
already available needs to be selected if
this macro is to be enabled
This will enable the application to output
QTouch measurement values to GPIO
pins, which can be used by a USB bridge
to view the output on Hawkeye or QTouch
Studio. This feature is currently supported
by EVK/TS 2080A and QT600 boards.
Please refer to section
Please refer to section 5.8.1
Please refer to section 5.8.1
65