ATQT600 Atmel, ATQT600 Datasheet - Page 57

• Manufacturer Part Number: ATQT600
• Description: KIT EVAL TOUCH FOR QT600
• Manufacturer: Atmel
• Series: QTouch™r

Specifications of ATQT600

• Sensor Type: Touch Screen
• Interface: USB
• Embedded: Yes, Other
• Utilized Ic / Part: ATtiny88, ATmega324PA, ATxmega128A1
• Processor To Be Evaluated: ATtiny88, ATmega324, ATxmega128
• Data Bus Width: 8 bit, 16 bit
• Interface Type: USB
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 1.6 V to 3.6 V
• Silicon Manufacturer: Atmel
• Kit Application Type: Sensor
• Application Sub Type: Touch Sensor
• Kit Contents: USB Bridge, MCU Cards, Touchpad Cards
• Svhc: No SVHC (15-Dec-2010)
• Mcu Supported Families: ATtiny88,
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Sensitivity: -
• Sensing Range: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

channels
for the application
Number of X lines
needed
Number of Y lines
needed
Rotors and sliders
required and
Number
ROTOR/SLIDERS
X_LINES on pins
as below(4-X lines)
X0- B0, X1- D2,X3
– B7, X4 – B5
Y_LINES on pins
as
Lines)
Y0A- D0, Y0B- C1,
Y1A-D5, Y1B-C4,
NUM_X_PORTS
Compiler tool chain
below
required
(2
Y-
of
Based on the number of channels,
since 8 channels is needed, 4 X lines
are supported.
NUM_X_LINES is 4
Based on the number of channels,
since 8 channels is needed, 2 Y lines
are supported
Yes
2
FILL_OUT_X_LINE_INFO(1,0),
FILL_OUT_X_LINE_INFO(2,2),
FILL_OUT_X_LINE_INFO(1,7),
FILL_OUT_YA_LINE_INFO(0),
FILL_OUT_YA_LINE_INFO(5),
FILL_OUT_YB_LINE_INFO(1),
FILL_OUT_YB_LINE_INFO(4),
2
IAR
Tiny88
Library_Selection_Guide.xls
Since 3 X- lines (6 channels ) are
used, Do not initialize 4
in
Hence channel6, channel7 need
not be used.
NUM_Y_LINES is 2.
Library
ATTiny88
Library_Selection_Guide.xls
Main file has to be edited based
on the configuration. Refer to
section 5.8.2.1
numbering
section5.6.6.1.2
This can be filled from the output
of the pin configurator tool in
QTouch Studio. Please refer to
section 5.8.2
Main file has to be edited based
on the configuration. Refer to
section 5.8.2.1
This can be filled from the output
of the pin configurator tool in
QTouch Studio. Please refer to
section 5.8.2
multiple(2) ports: PORTB, PORTD
Supported compiler tool chains
listed in 5.7.2.2
Since X lines are spread on a
x_line_info[NUM_X_LINES].
variants
is
is
Or
Or
listed
. Refer channel
from
supported
listed
th
in
element
the
the
for
57
in