101-0530 Rabbit Semiconductor, 101-0530 Datasheet - Page 20

• Manufacturer Part Number: 101-0530
• Description: KIT TOOL FOR LP3500 INTL
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: Single Board Computers (SBC)r

Specifications of 101-0530

• Contents: Demo Board, Serial Cable, Software and Documentation
• For Use With/related Products: Rabbit 3000-based products, except RCM30/3100, LP3500
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

2.3 Installing Dynamic C
If you have not yet installed Dynamic C version 7.26P (or a later version), do so now by
inserting the Dynamic C CD in your PC’s CD-ROM drive. The CD will auto-install unless
you have disabled auto-install on your PC.
If the CD does not auto-install, click
browse for the Dynamic C
installation once you have selected the
The Dynamic C User’s Manual provides detailed instructions for the installation of
Dynamic C and any future upgrades.
2.4 Starting Dynamic C
Once the LP3500 is connected to your PC and to a power source, start Dynamic C by dou-
ble-clicking on the Dynamic C icon on your desktop or in your
If you are using a USB port to connect your computer to the LP3500, choose
Project Options
Click
Dynamic C assumes, by default, that you are using serial port COM1 on your PC when
you are running a program. If you are using COM1, then Dynamic C should detect the
LP3500 and go through a sequence of steps to cold-boot the LP3500 and to compile the
BIOS. If the error message “Rabbit Processor Not Detected” appears, you have probably
connected to a different PC serial port such as COM2, COM3, or COM4. You can change
the serial port used by Dynamic C with the
recognize the LP3500 by selecting
Try the different COM ports in the
nected to. If you still can’t get Dynamic C to recognize the target on any port, then the
hookup may be wrong or the COM port might not working on your PC.
Dynamic C automatically uses a maximum debug baud rate of 38,400 bps when an
LP3500 series board is in use.
14
OK
NOTE: If you have an earlier version of Dynamic C already installed, the default instal-
.
lation of the later version will be in a different folder, and a separate icon will appear on
your desktop.
and select “Use USB to Serial Converter” on the
setup.exe
Reset Target/Compile BIOS
OPTIONS
Start > Run
setup.exe
file on your CD drive. Click
OPTIONS
menu until you find the one you are con-
from the Windows
file.
menu, then try to get Dynamic C to
Start
on the
Communications
Start
menu.
OK
Compile
to begin the
button and
Options >
Fox (LP3500)
menu.
tab.