101-0530 Rabbit Semiconductor, 101-0530 Datasheet - Page 94

• Manufacturer Part Number: 101-0530
• Description: KIT TOOL FOR LP3500 INTL
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: Single Board Computers (SBC)r

Specifications of 101-0530

• Contents: Demo Board, Serial Cable, Software and Documentation
• For Use With/related Products: Rabbit 3000-based products, except RCM30/3100, LP3500
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

B.2.2 Demonstration Board
The Prototyping Board is actually both a demonstration board and a prototyping board.
As a demonstration board, it can be used to demonstrate the functionality of the LP3500
right out of the box without any modifications to either board. There are no jumpers or dip
switches to configure or misconfigure on the Prototyping Board so that the initial setup is
very straightforward.
The Prototyping Board comes with the basic components necessary to demonstrate the
operation of the LP3500. Four LEDs (DS1–DS4) are connected to PD0–PD3, and four
switches (S1–S4) are connected to PE0, PE1, PE4, and PE5 to demonstrate the interface to
the Rabbit 3000 microprocessor.
NOTE: Before running sample programs based on the LP3500, you will have to plug in
the LP3500 to the Prototyping Board as described in Chapter 2, “Getting Started.”
B.2.3 Prototyping Area
Small to medium circuits can be prototyped using point-to-point wiring with 20 to 30 AWG
wire on the prototyping area. Raw DC input, VIN, and GND lines surround the prototyp-
ing area.
The resistor pack located next to the pushbutton switches may be removed to disconnect
the LEDs and pushbutton switches from the Prototyping Board circuits, giving your
LP3500 exclusive access to what you may develop in the prototyping area.
+K and VIN are tied together by resistor R1 located beside header J44. Cut off R1 if you
intend to supply a separate +K.
88
Fox (LP3500)