101-0681 Rabbit Semiconductor, 101-0681 Datasheet - Page 17

• Manufacturer Part Number: 101-0681
• Description: KIT DEVELOPMENT RCM3700 INT'L
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: MPU Moduler

Specifications of 101-0681

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: Rabbit 3000
• Interface Type: Ethernet
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 4.75 V to 5.25 V
• For Use With/related Products: RCM3700
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 101-681; 101-681

3.1 Introduction
To help familiarize you with the RCM3700 modules, Dynamic C includes several sample
programs. Loading, executing and studying these programs will give you a solid hands-on
overview of the RCM3700’s capabilities, as well as a quick start with Dynamic C as an
application development tool.
In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Your RCM3700 must be plugged in to the Prototyping Board as described in Chapter 2,
2. Dynamic C must be installed and running on your PC.
3. The programming cable must connect the programming header (J2) on the RCM3700
4. Power must be applied to the RCM3700 through the Prototyping Board.
Refer to Chapter 2, “Getting Started,” if you need further information on these steps.
To run a sample program, open it with the
F9
Complete information on Dynamic C is provided in the Dynamic C User’s Manual.
RabbitCore RCM3700 User’s Manual
. The RCM3700 must be connected to a PC using the programming cable.
“Getting Started.”
to your PC.
To develop and debug programs for the RCM3700 (and for all
other Rabbit hardware), you must install and use Dynamic C.
NOTE: The sample programs assume that you have at least an elementary grasp of the C
programming language. If you do not, see the introductory pages of the Dynamic C
User’s Manual for a suggested reading list.
3. R
UNNING
File
S
menu, then compile and run it by pressing
AMPLE
P
ROGRAMS
15