5.07.01 FLASHER ARM Segger Microcontroller Systems, 5.07.01 FLASHER ARM Datasheet - Page 43

• Manufacturer Part Number: 5.07.01 FLASHER ARM
• Description: PROGRAMMER JTAG FOR ARM CORES
• Manufacturer: Segger Microcontroller Systems
• Type: In-System Programmerr

Specifications of 5.07.01 FLASHER ARM

• Contents: Programmer
• For Use With/related Products: ARM7, ARM9, Cortex
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 899-1002

5.1.2
5.1.2.1 Pull-up/pull-down resistors
5.1.3
Flasher ARM (UM08007)
We strongly advise following the recommendations given by the chip manufacturer.
These recommendations are normally in line with the recommendations given in the
table Pinout on page 42. In case of doubt you should follow the recommendations
given by the semiconductor manufacturer.
Unless otherwise specified by developer’s manual, pull-ups/pull-downs are recom-
mended to be between 2.2 kOhms and 47 kOhms.
Pin 19 of the connector can be used to supply power to the target hardware. Supply
voltage is 5V, max. current is 300mA. The output current is monitored and protected
against overload and short-circuit.
Power can be controlled via the J-Link commander. The following commands are
available to control power:
Table 5.2: Command List
power on
power off
power on perm
power off perm
Target board design for JTAG
Target power supply
Command
Switch target power on
Switch target power off
Set target power supply default to "on"
Set target power supply default to "off"
© 2004-2009 SEGGER Microcontroller GmbH & Co. KG
Explanation
43