ST7MDT10-DVP3 STMicroelectronics, ST7MDT10-DVP3 Datasheet - Page 10

• Manufacturer Part Number: ST7MDT10-DVP3
• Description: EMULATOR REAL TIME ST7
• Manufacturer: STMicroelectronics
• Type: Emulatorr

Specifications of ST7MDT10-DVP3

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST7 Flash MCUs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Caution:
STEP 3: Plug the flat cables into the
connectors on the TEB. Connect the probe to
your application in place of your MCU.
For detailed instructions refer to your
ST7xxxx-DVP3 Probe User Guide .
STEP 4: Connect the ferrite clip to the power
supply cord between the power supply and
and your emulator.
Getting Started with ST7-DVP3
2.2
Warning: Never power on your application board while your emulator is powered off—this can
10/44
STEP 5: Connect the power supply to your ST7-DVP3 emulator. For more information, refer
to
STEP 6: Power up your ST7-DVP3 emulator.
STEP 7: Power up your application.
Section 4.3.2: Power supply
!
Figure 3: Connect your PC
Before making hardware connections,
ensure that both the emulator and your
application board are powered OFF
Quick set up for emulation configuration
seriously damage your emulator. When powering up, always turn on your emulator
first. When powering off, always power off your application first.
Voltage selector switch
Use USB or parallel
on page 17.
connection
STEP 1: Connect your emulator to your host
PC via parallel or USB port.
For
Connectivity
Warning: Never have an application running
STEP 2: Select the operating voltage, either
3.3V or 5V, with the voltage selector switch.
Figure 4: Connect your application
!
more
Power supply cable
when you set the operating voltage.
Setting
application
can seriously damage the emulator.
on page 12.
ST7-DVP3 Emulator User Manual
details
it
Flat cables
refer
Adapter
to
is
running
3.3V
ST7-DVP3 TEB
to
Chapter 3:
while
at
5V
an