ST7MDT10-DVP3 STMicroelectronics, ST7MDT10-DVP3 Datasheet - Page 30

• Manufacturer Part Number: ST7MDT10-DVP3
• Description: EMULATOR REAL TIME ST7
• Manufacturer: STMicroelectronics
• Type: Emulatorr

Specifications of ST7MDT10-DVP3

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST7 Flash MCUs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Appendix B: Changing the TEB
APPENDIX B:CHANGING THE TEB
30/44
ST7-DVP3 emulators have a modular design that is based on two emulation
boards. The Main Emulation Board (MEB) is identical for all ST7-DVP3
emulators. The Target Emulation Board (TEB) is specific to an ST7 or a family of
ST7 microcontrollers. Modifying any ST7-DVP3 emulator requires changing the
TEB and obtaining the Adapter kit that is specific to the target ST7's package.
In order to replace your ST7-DVP3 TEB on your emulator, follow this procedure:
1 Ensure that the ST7-DVP3 emulator is powered off. When powering off, shut
2 Remove the two nuts that secure the TEB to the MEB, as shown in
3 Place your fingers between the TEB and the MEB along the edges that are
4 Orient the replacement TEB as shown in
ST7-DVP3 TEB
down any connected application, then power off the development board.
Disconnect the power supply from your development board.
parallel to the J5 and J6 connectors. Lift up on the TEB, while leveraging
against the MEB, until the two boards separate.
of the TEB by the two 60-pin connectors that link it to the MEB. On top of the
Figure 14: Unscrew and remove the TEB
Figure 15
ST7-DVP3 Emulator User Manual
J6
. You can identify the bottom
ST7-DVP3 MEB
Figure 14
J5
.