HS2140EPI61H Renesas Electronics America, HS2140EPI61H Datasheet - Page 203

• Manufacturer Part Number: HS2140EPI61H
• Description: DEV EMULATOR BASE UNIT H8S/2140
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of HS2140EPI61H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8S/2140
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

[General] page (cont)
The MCUs selectable by the [Device] option and options that depend on the MCUs are listed below. To emulate
an MCU with a description in the Expansion Hardware column, connect the correct expansion hardware.
Table 8.2
[Device] Option
Custom
H8S/2148
H8S/2147
H8S/2144
H8S/2143
H8S/2142
H8S/2138
H8S/2137
H8S/2134
H8S/2133
H8S/2132
H8S/2130
H8S/2128
H8S/2127
H8S/2126
H8S/2124
H8S/2123
H8S/2122
H8S/2120
H8S/2147N
H8S/2149
H8S/2169
Notes: 1. Target in [Mode] is only available when the target system is connected.
[Break on access error]
[User VCC Threshold]
[User Signals]
[Driver]
[Change driver in start up]
2. Target and Target/2 in [Clock] are only available when the target system is connected.
Environment for the H8S/2148 E6000 Emulator CPU 2000 Debugging Platform
[Mode] Option
The MCU previously selected
1 (normal mode)
2 (advanced mode, on chip ROM)
3 (normal mode, on chip ROM)
Target
When this box is checked, a break (the user program stops) occurs if
your program accesses an access-prohibited area or writes to a write-
protected area.
Sets the voltage level for the user system. [Down] will be displayed in
[User System Voltage] of the [Extended Monitor] window when the actual
user VCC of the target system is lower than the specified value.
When this box is checked, the reset, NMI, and standby signals from the
user system are enabled. Do not input the standby signal because the
hardware standby function is not supported.
Displays the E6000 driver that is currently installed.
When this box is checked, selection of a driver will be available next time
the emulator is connected.
[Clock] Option
Main: 8MHz,
Main: 10MHz,
Main: 12MHz,
Main: 16MHz,
Main: 20MHz,
Main: Target,
Main: Target/2
Expansion Hardware
None
HS2149EIO61H
HS2169EIO61H
183