ZGP323ICE01ZEM Zilog, ZGP323ICE01ZEM Datasheet - Page 24

• Manufacturer Part Number: ZGP323ICE01ZEM
• Description: PLATFORM DEV ICE Z8 GP ZGP323
• Manufacturer: Zilog

Specifications of ZGP323ICE01ZEM

• Processor To Be Evaluated: ZGP323
• Interface Type: RS-232, Ethernet, USB
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 269-3399; ZGR323ICE01ZEM

UM017503-0208
LED Indicators
External Interface Connectors
•
•
•
15. Click Blank Check to verify that the OTP chip is actually blank.
16. Click Burn to program the OTP chip with the contents of emulator RAM. The OTP
17. When the burn is complete, click OTP Checksum to calculate the checksum of data
18. Click Close to close the OTP Programming window.
There are three sets of dual LED indicators on the Z8 GP ICE, as described below:
1. The dual ICE RUN LED on the front panel, see
2. The dual 3.3 V DC/1.8 V DC LED on the rear panel, see
3. The dual LAN/LINK LED on the rear panel, see
There are five external interface connectors (P15, P16, P17, J8, and J9) on the Z8 GP ICE
as explained below:
•
•
•
Select the size of the serial number (1, 2, 3, or 4 bytes) in the Serial Number Size
area.
Enter the starting serial number in the Serial Number field.
In the Address field, enter the address of the serial number.
chip contents is also verified.
on the OTP chip and compare it to the RAM check-sum calculated earlier.
status. If the top LED is ON, the emulator is executing the system code. When the top
LED is off, emulation has stopped. If the bottom LED is ON, the emulator is not func-
tioning properly, contact technical support for assistance.
the status of internal voltages. Both LEDs are normally illuminated when power is
connected.
net status. The LINK LED indicates that the Ethernet connection is live. The LAN
LED indicates that data is being transferred across the connected network.
Connectors P16 and P17 are used to connect the emulator to the target pod and adapter
board assembly, see
The OTP Programming connector P15 is used to connect the emulator to the OTP pro-
gramming module.
Connector J8 on the emulator front panel (see
vides a ground connection on all three pins.
Z8 GP
™
Figure 4
ZGP323 In-Circuit Emulator and Development Platform
on page 5.
Figure 4
Figure 5
Figure 3
and
on page 5, indicates emulator
Figure 3
on page 4, indicates Ether-
Figure 5
on page 4, indicates
on page 5), pro-
Sample Project
User Manual
21