M3062PT-EPB Renesas Electronics America, M3062PT-EPB Datasheet - Page 13

• Manufacturer Part Number: M3062PT-EPB
• Description: EMUL PERSONALITY KIT M16C/62P
• Manufacturer: Renesas Electronics America

Specifications of M3062PT-EPB

• Accessory Type: Probe Accessory Kit
• For Use With/related Products: PC7501, M16C/62
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Notes on Downloading Firmware:
Notes on Self-check:
Note on Quitting the Emulator Debugger:
Note on Final Evaluation:
Notes on Power Supply to the Target System:
Note on RESET* Input:
• Before using this product for the first time, it is necessary to download the dedicated firmware.
• Do not shut off the power while downloading the firmware. If this happens, the product will not
• Download the firmware with the target system not connected.
• If the self-check does not result normally (excluding target system errors), the emulation probe may
• Run the self-check with the target system not connected.
• To restart the emulator debugger, always shut power to the emulator module off once and then on
• Be sure to evaluate your system with an evaluation MCU. Before starting mask production,
• Pins Vcc1 and Vcc2 are connected to the target system to observe the voltage. Therefore, the power
• The voltage of the target system should be as follows.
• Do not change the voltage of the target system after turning on the power.
• A low input to pin RESET* from the target system is accepted only when a user program is being
Please note that, to do this, it is necessary to start up the emulator main unit in maintenance mode.
For downloading firmware, see "4.2 Downloading Firmware" (page 48). Once the firmware has
been downloaded, the product can be used by simply turning on the power.
start up properly. If the power is shut off unexpectedly, redownload the firmware.
be damaged. Then contact your local distributor.
again.
evaluate your system and make final confirmation with a CS (Commercial Sample) version MCU.
is not supplied to the target system from the emulator, design your system so that the target system
is powered separately.
executed (when the RUN status LED on the PC7501's front panel is lit).
(1) When JP1 is set as Vcc1 = Vcc2:
(2) When JP1 is set as Vcc1 > Vcc2:
2.7 V ≤ Vcc1 = Vcc2 ≤ 5.5 V
4.8 V ≤ Vcc1 ≤ 5.2 V
2.7 V ≤ Vcc2 < Vcc1
IMPORTANT
( 11 / 80 )