M3062PT-EPB Renesas Electronics America, M3062PT-EPB Datasheet - Page 15

• Manufacturer Part Number: M3062PT-EPB
• Description: EMUL PERSONALITY KIT M16C/62P
• Manufacturer: Renesas Electronics America

Specifications of M3062PT-EPB

• Accessory Type: Probe Accessory Kit
• For Use With/related Products: PC7501, M16C/62
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Note on Access Prohibited Area:
Notes on Stack Area:
Notes on Reset Vector Area:
Note on Accessing Address 00000h:
Note on Stop and Wait Modes:
• You cannot use internally reserved areas. Write signals to the areas will be ignored, and values read
• With this product, a maximum 8 bytes of the user stack is consumed as a work area.
• With this product, the interrupt stack pointer (ISP) is set at 00500h and used as a stack area after
• Memory in the emulator main unit is always selected as a reset vector area (FFFFCh--FFFFFh) in
• You can change data in the reset vector area only when the user program is stopped.
• Do not access the reset vector area as data. It may not be accessed properly, and the program may
• With the M16C Series MCUs, when a maskable interrupt is generated, the interrupt data (interrupt
• Do not single step an instruction shifting to stop or wait mode. It may cause communication errors.
Even if the user stack does not have an enough area, do not use areas which cannot be used as a stack
For this malfunction, when the reading out to address 00000h is generated excluding the interrupt, the
will be undefined.
(SFR area, RAM area which stores data, or ROM area) as a work area. Using areas like this is a cause
of user program crashes and destabilized emulator control.
a reset is released.
order to operate the evaluation MCU in the emulator-dedicated mode. Set the contents of the reset
vector area in one of the following ways.
not run properly in the next bus cycle.
number and interrupt request level) stored in address 00000h is read out. Also, the interrupt request
bit is cleared when address 00000h is read out. Consequently, when the address 00000h readout
instruction is executed or when address 00000h is read out in the cause of a program runaway, a
malfunction occurs in that the interrupt is not executed despite the interrupt request, because the
request bit of the highest priority interrupt factor enabled is cleared.
WARNING LED (yellow) lights up to alarm. When this LED lights, there is a possibility of wrong
access, therefore check the user program.
(1) Download a user program to an area including the reset vector area.
(2) Set the reset vector using a memory window of the emulator debugger etc.
IMPORTANT
( 13 / 80 )