HS7760KCM02H Renesas Electronics America, HS7760KCM02H Datasheet - Page 35

• Manufacturer Part Number: HS7760KCM02H
• Description: ON CHIP DEBUG EMULATOR W/TRACE
• Manufacturer: Renesas Electronics America

Specifications of HS7760KCM02H

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.2.2
(1) When the emulator is a PCI card:
(2) When the emulator is a PCMCIA card:
Notes: 1. For the SH7729, SH7729R, and SH7622 E10A emulators, there is a check box for
1. Shut the operating system down and turn off the power to the host computer.
2. Insert the PCI-card emulator in a slot on the host computer. Refer to section 2.3,
Connecting the Card Emulator to the Host Computer.
3. Start the host computer and log-on with an administrator-level user name.
4. Install the HDI. (For a component, be sure to select [PCI Card Driver]. There is a check
box for selecting the type name of the product under the [PCI Card Driver] component. Select
the appropriate type name. If the correct name is not selected, the correct driver will not be
installed, and the emulator will not operate.)
5. Restart the host computer.
1. Shut the operating system down and turn off the power to the host computer.
2. Insert the PCMCIA-card emulator in the host computer’s slot. Refer to section 2.3,
Connecting the Card Emulator to the Host Computer.
3. Start the host computer and log-on with an administrator-level user name.
4. During HDI installation, the setting value should be checked beforehand because inquiries
are made about the resource used by the PCMCIA-card emulator.
Start the [Start] menu -> [Programs] -> [Administrative Tools (Common)] -> [Windows NT
Diagnostics], check the status of the IRQ, I/O port, and memory from the resource panel, and
determine the setting values that do not conflict with other devices. (The following resources
are used: IRQ: one channel, I/O port: H’F byte, and memory: H’4000 byte.)
5. Install the HDI. (For a component, be sure to select [PC Card Driver (PCMCIA)]. There is
a check box for selecting the type name of each product under the [PC Card Driver
(PCMCIA)] component. Select the appropriate type name. If the correct name is not selected,
the correct driver will not be installed and the emulator will not operate.)
6. Restart the host computer.
2. The driver that has been selected in the [Drivers] component starts after the host
Installing under Windows NT 4.0 Operating System
selecting the MODEL name that appears on the component list. Select the correct type
name.
computer is initiated. If the host computer is initiated with the card disconnected or
with the incorrect driver installed, the driver cannot initiate and the service control
manager informs the system of an error. This, however, is not a problem.
9