DEMO9S08QG8 Freescale Semiconductor, DEMO9S08QG8 Datasheet - Page 4

• Manufacturer Part Number: DEMO9S08QG8
• Description: BOARD EVAL FOR MC9S08QG4/8
• Manufacturer: Freescale Semiconductor

Specifications of DEMO9S08QG8

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

CAUTIONARY NOTES
♦ Electrostatic Discharge (ESD) prevention measures should be used when handling this
♦ Axiom Manufacturing does not assume any liability arising out of the application or use of
♦ EMC Information on the APS08QG8SLK board:
TERMINOLOGY
This development board uses option selection jumpers. A jumper is a plastic shunt that
connects 2 terminals electrically. Terminology for application of the option jumpers is as
follows:
Throughout this document, where used, the name APS08QG8SLK applies equally to the
APS08QG8SLK, CSM9S08QG8SLK, and PBS08QG8SLK.
4
product. ESD damage is not a warranty repair item.
any product or circuit described herein; neither does it convey any license under patent
rights or the rights of others.
a) This product, as shipped from the factory with associated power supplies and cables,
b) This product is designed and intended for use as a development platform for hardware
c) In a domestic environment, this product may cause radio interference in which case the
d) Attaching additional wiring to this product or modifying the product operation from the
has been verified to meet with FCC requirements as a CLASS A product.
or software in an educational or professional laboratory.
user may be required to take adequate prevention measures.
factory configuration may affect its performance and cause interference with other
apparatus in the immediate vicinity. If such interference is detected, suitable mitigating
measures should be taken.
Jumper – a plastic shunt that connects 2 terminals electrically
Jumper on, in, or installed - jumper is installed such that 2 pins are connected together
Jumper off, out, or idle - jumper is installed on 1 pin only. It is recommended that
jumpers be idled by installing on 1 pin so they will not be lost.
Cut-Trace – a circuit trace connection between component pads. The circuit trace may
be cut using a razor knife to break the default connection. To reconnect the circuit,
simply install a suitably sized 0-ohm resistor or attach a wire across the pads.
Freescale Semiconductor