KP125 EVAL BOARD Infineon Technologies, KP125 EVAL BOARD Datasheet - Page 6

• Manufacturer Part Number: KP125 EVAL BOARD
• Description: BOARD EVALUATION KP125
• Manufacturer: Infineon Technologies
• Type: Pressure Sensorr

Specifications of KP125 EVAL BOARD

• Contents: Fully Assembled Evaluation Board
• For Use With/related Products: KP125
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: KP125EVALBOARDIN

1.1
1.1.1
The board may be supplied alternatively by battery or a DC voltage power supply.
Note: In case of battery supply it is recommended to switch it on only for short term. Otherwise the lifetime of the
1.1.2
The pressure value or the output voltage can be read on a LCD display. The mode can be selected with a switch.
The default boards are equipped with a 3.5 digits LCD display (see
precision 4.5 digits display is possible.
Figure 1
1.1.2.1
The exact output voltage value can only be measured via the connector CON2 (see
PC-Interface
the LCD display. This value is not accurate according to the data sheet. Voltage and mBar display values can be
adjusted via potentiometers (see
Figure 2
User’s Manual
battery is not very long (10 to 20 hours for a 9V block battery).
Technical Description
Power Supply
Display
3.5 digits LCD Display
Display Calibration
Display Configuration via Potentiometers
(Page
13). An output voltage value and the equivalent value in mBar of the sensor can be read from
Figure
2).
6
Figure
Evalkit for Pressure Sensors
1). Alternatively, the assembly of a
Figure
Rev. 1.1, 2007-11-23
3) or read out via
KP12x Kit
Overview