Y92S-38 Omron, Y92S-38 Datasheet - Page 55

• Manufacturer Part Number: Y92S-38
• Description: LOCK KEY PEN FOR H3DS RELAYS
• Manufacturer: Omron
• Series: H3DSr

Specifications of Y92S-38

• Accessory Type: Tool - Lock Key Pen
• For Use With/related Products: H3DS Series
• For Use With: H3DS-SLCAC24-230/DC24 - TIMER CAGE CLAMP 17.5MM 4MODESH3DS-MLCAC24-230/DC24-48 - TIMER CAGE CLAMP 17.5MM 8MODESZ2395 - RELAY TIME DELAY 4MODE DIN MNTZ2394 - RELAY TIME DELAY 1MODE DIN MNTZ2393 - RELAY TIME DELAY 8MODE DIN MNTZ2392 - RELAY TIME DELAY 1MODE DIN MNT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Color: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: Y92S38; Z2396

H3DS-X
Installation of Cage Clamp Terminal Models
I
A flat-blade screwdriver should be used to install the cables.
Applicable Screwdriver
G Flat-blade, Parallel-tip, 2.5 mm diameter
Examples:FACOM AEF.2.5 × 75E
VESSEL No. 9900-(-)2.5 × 75
WAGO 210-119
WIHA 260/2.5 × 40
I
Applicable Wire Sizes
0.2 to 1.5 mm
Applicable Wire Type
Solid wires, stranded wires, flexible wires, or wires with ferrules
can be used.
(See note 1) < 1.8 ≤ Diameter D (mm) ≤ 3.0 (see note 2)
Conductor diameter d (mm) or length of sides a and b (mm) ≤ 1.6
Note: 1. If the overall diameter of the wire is less than 1.8 mm,
I
Use wires of the applicable sizes specified above. The length of
the exposed conductor should be 6 to 7 mm.
• Flat-blade, Parallel-tip
• Flat-blade, Flared-tip
8
Wires with Ferrules
Wiring
Tools
Applicable Wires
OK
Fig. 1 Exposed Conductor Length
2.5 dia.
2. If the overall diameter of the wire is over 2.8 mm, it will
do not insert the wire past the conductor. Refer to the
following diagrams.
be difficult to use double wiring.
2
, AWG24 to AWG16
Cannot be used.
6 to 7 mm
NG
2. Insert the exposed conductor into the wire connection
Wiring Precautions
Always insert the screwdriver straight into the hole, never at an
angle. The clamp spring may bend if the screwdriver is not
straight.
3. Pull out the screwdriver.
Do not move the screwdriver side to side in the clamp hole. The
clamp spring may bend if the screwdriver is moved sideways.
Wire
connection
holes
Release
holes
Fig. 2 Wire Connection Holes and Release Holes
Use the following procedure
1. Insert the specified screwdriver into the release hole locate
Fig. 3 Section A-A of Fig. 2
hole.
beside the wire connection hole where the wire is to be
inserted.
Wire connection hole
Release hole
Screwdriver
A
A
Insert
Insert
Insert
Pull out
H3DS-X