HD6473834HV Renesas Electronics America, HD6473834HV Datasheet - Page 234

• Manufacturer Part Number: HD6473834HV
• Description: MCU 5V 32K PB-FREE 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Lr

Specifications of HD6473834HV

• Core Processor: H8/300L
• Core Size: 8-Bit
• Speed: 5MHz
• Connectivity: SCI
• Peripherals: LCD, PWM
• Number Of I /o: 71
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: OTP
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 12x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

9.6.4
Timer G is an 8-bit timer with input capture and interval timer functions.
Timer G Functions: Timer G is an 8-bit timer/counter that functions as an input capture timer or
an interval timer. These two functions are described below.
Input capture
input signal
Sampling
clock
Noise canceller
output
Input capture timer operation
Timer G functions as an input capture timer when bit TMIG of port mode register 1 (PMR1) is
set to 1.*
At reset, timer mode register G (TMG), timer counter G (TCG), input capture register GF
(ICRGF), and input capture register GR (ICRGR) are all initialized to H'00.
Immediately after reset, TCG begins counting an internal clock with a frequency of divided
by 64 ( /64). Four other internal clocks can be selected using bits CKS1 and CKS0 of TMG.
At the rising edge/falling edge of the input capture signal input to pin TMIG, the value of TCG
is copied into ICRGR/ICRGF. If the input edge is the same as the edge selected by the IIEGS
bit of TMG, then bit IRRTG is set to 1 in IRR2. If bit IENTG is also set to 1 in IENR2, a CPU
interrupt is requested. For details on interrupts, see section 3.3, Interrupts.
TCG can be cleared to 0 at the rising edge, falling edge, or both edges of the input capture
signal as determined with bits CCLR1 and CCLR0 of TMG. If TCG overflows while the input
capture signal is high, bit OVFH of TMG is set. If TCG overflows while the input capture
signal is low, bit OVFL of TMG is set. When either of these bits is set, if bit OVIE of TMG is
currently set to 1, then bit IRRTG is set to 1 in IRR2. If bit IENTG is also set to 1 in IENR2,
then timer G requests a CPU interrupt. For further details see 3.3, Interrupts.
Timer G has a noise canceller circuit that rejects high-frequency pulse noise in the input to pin
TMIG. See 9.6.3, Noise Canceller Circuit, for details.
Timer Operation
Figure 9.10 Noise Canceller Circuit Timing (Example)
Rejected as noise
217