ETRX3DVKA357 Telegesis Ltd, ETRX3DVKA357 Datasheet - Page 18

• Manufacturer Part Number: ETRX3DVKA357
• Description: KIT DEVELOPMENT FOR ETRX357
• Manufacturer: Telegesis Ltd
• Type: ZigBit™r

Specifications of ETRX3DVKA357

• Frequency: 2.4GHz
• Kit Contents: 3x ETRX35xDV Development Boards, 3x USB Cables, 2x ETRX35x On Carrier Boards, 2x ETRX35xHR Boards
• Mcu Supported Families: ETRX3
• Silicon Manufacturer: Telegesis
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: ETRX357
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 920-1009; ETRX2DVK357

ETRX35x Development Kit
11.1 Software Set-up
Before installing Telegesis Terminal, you must install .NET Framework Version 1.1 Redistributable
Package from Microsoft. This is currently available at
www.microsoft.com/downloads/browse.aspx?displaylang=en&productID=C9C8FCFB-BFF3-40CA-
B59D-216F6850000A.
Note that Version 2 or later is not sufficient as it supplements Version 1.1 but does not replace it.
Then download Telegesis Terminal from our website at
www.telegesis.com/telegesis_zigbee_technology_-_technical_support_/telegesis_terminal.htm.
After installing the Telegesis Terminal Application program the command buttons for the firmware
will be shown at the bottom of the window. In order to use the Telegesis Terminal software, select
the correct COM port and the connection parameters (ETRX35x default 19200, 8 bits, no parity, no
flow control) and press the connect button. These settings are automatically retained each time
the software is re-started.
11.2 Features of the Telegesis Terminal Application for ETRX35x
To make life easier all of the commands have been pre-defined and conveniently grouped at the
bottom of the terminal window. Pressing a button (where no parameters are required) causes the
corresponding command to be issued instantly. Where a parameter is required the command is
shown in the Command bar and the required parameter can be entered manually. In order to
issue the command from the command bar simply press the <enter> or the Send button. To see
the parameters for a specific command, move and hold the mouse pointer over the chosen
command button - Figure 18.
Figure 18. Screen tips for parameters
Every EUI64 number reporting in is listed in a separate window which can be opened or closed by
clicking on the button labelled ‘Device List’. If a device ID is required as a parameter in the
command bar, simply double click on an entry in the device list and its EUI64 will be automatically
transferred to the current cursor position of the command bar.
To allow for easier identification, the EUI64 IDs in the device list can be named. When right
clicking on any EUI64 ID a name can be associated with the respective ID - Figure 19.
©2010 Telegesis (UK) Ltd
- 18 -
ETRX35xDVK Product Manual (Rev 1.01)