PSB3186FV14NT Infineon Technologies, PSB3186FV14NT Datasheet - Page 158

• Manufacturer Part Number: PSB3186FV14NT
• Manufacturer: Infineon Technologies

Specifications of PSB3186FV14NT

• Number Of Line Interfaces: 1
• Control Interface: HDLC
• Lead Free Status / Rohs Status: Not Compliant

ISAC-SX TE
PSB 3186
Detailed Register Description
0: A write access to CS2-0 has effect on the configuration of D- and C/I-channel,
whereas a read access delivers the D-channel configuration only.
1: A write access to CS2-0 has effect on the configuration of the C/I-channel only,
whereas a read access delivers the C/I-channel configuration only.
TIC_DIS ... TIC Bus Disable
0: The last octet of IOM channel 2 (12th timeslot) is used as TIC bus.
1: The TIC bus is disabled. The last octet of the last IOM time slot (TS 11) can be used
as every time slot.
EN_BCL ... Enable Bit Clock BCL
0: The BCL clock is disabled
1: The BCL clock is enabled.
CLKM ... Clock Mode
If the transceiver is disabled (DIS_TR = ’1’) the DCL from the IOM-2 interface is an input.
0: A double bit clock is connected to DCL
1: A single bit clock is connected to DCL
For general information please refer to
Chapter
3.7.
DIS_OD ... Disable Open Drain Drivers
0: DU/DD are open drain drivers
1: DU/DD are push pull drivers
DIS_IOM ... Disable IOM
DIS_IOM should be set to ’1’ if external devices connected to the IOM interface should
be “disconnected“ e.g. for power saving purposes or for not disturbing the internal IOM
connection between layer 1 and layer 2. However, the ISAC-SX TE internal operation
between S-transceiver, B-channel and D-channel controller is independent of the
DIS_IOM bit.
0: The IOM interface is enabled
1: The IOM interface is disabled. The FSC, DCL clock outputs have high impedance;
clock inputs are active; DU, DD data line inputs are switched off and outputs have high
impedance; except in TE/LT-T mode the DU line is input (“0”-level causes activation), so
the DU pin must be terminated (pull up resistor).
Data Sheet
158
2003-01-30