se97pw/1 NXP Semiconductors, se97pw/1 Datasheet - Page 18

• Manufacturer Part Number: se97pw/1
• Description: Se97 Memory Module Temp Sensor With Integrated Spd
• Manufacturer: NXP Semiconductors

NXP Semiconductors
8. Register descriptions
SE97_2
Product data sheet
8.1 Register overview
This section describes all the registers used in the SE97. The registers are used for
latching the temperature reading, storing the low and high temperature limits, configuring,
the hysteresis threshold and the ADC, as well as reporting status. The device uses the
pointer register to access these registers. Read registers, as the name implies, are used
for read only, and the write registers are for write only. Any attempt to read from a
write-only register will result in reading ‘0’s. Writing to a read-only register will have no
effect on the read even though the write command is acknowledged. The Pointer register
is an 8-bit register. All other registers are 16-bit.
Table 7.
A write to reserved registers my cause unexpected results which may result in requiring a
reset by removing and re-applying its power.
Address (hex)
n/a
00h
01h
02h
03h
04h
05h
06h
07h
08h to 21h
22h
23h to FFh
Register summary
Default state (hex)
n/a
0015h/0017h
0000h
0000h
0000h
0000h
n/a
1131h
A200h
0000h
0000h
0000h
Rev. 02 — 12 October 2007
Memory module temp sensor with integrated SPD
Register name
Pointer Register
Capability Register (B-grade = 0017h, C-grade = 0015h)
Configuration Register
Upper Boundary Alarm Trip Register
Lower Boundary Alarm Trip Register
Critical Alarm Trip Register
Temperature Register
Manufacturer ID Register
Device ID/Revision Register
reserved registers
SMBus Register
reserved registers
© NXP B.V. 2007. All rights reserved.
SE97
18 of 43