ST7MDT10-TEB/DVP STMicroelectronics, ST7MDT10-TEB/DVP Datasheet - Page 12

• Manufacturer Part Number: ST7MDT10-TEB/DVP
• Description: KIT ADAPTERS ST7
• Manufacturer: STMicroelectronics

Specifications of ST7MDT10-TEB/DVP

• Accessory Type: Target Board
• For Use With/related Products: ST7MDT10-DVP3 Emulator
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Connecting to your application board
3.2
Note:
12/31
SO16 package
This procedure tells you how to connect the ST7MDT10-DVP3 emulator to your
application board when your target ST7 microcontroller is in an SO16 package.
1 Solder one of the SO16 connectors that are provided with your emulator, to
Care must be taken when designing the circuitry surrounding the component-side footprint for
the emulated SO16 device on your application board. This is because the provided
connectors have larger connection pins than the actual SO16 microcontroller package.
If wire on wire connections are made on the SO16
(150-mil width) footprint between the two 8-pin rows
(as shown on the right), a short circuit may occur
when soldering the SO16 (150-mil width) connector
on the same footprint.
To avoid short circuits we recommend that wire on
wire connections be done as shown in the illustration
on the right.
2 Ensure that the emulator and your application board are powered off.
3 Connect the 34-pin flat cable to the J1 connector on the ST7MDT10-DVP3
4 Plug the other end of the 34-pin flat cable into J1 on the DIP16/SO16 device
5 Remove the DIP16 sockets from the device adapter. These sockets may get in
your application board.
TEB, making certain to align the orientation guides as shown in
J2 connector on your TEB is not used in this configuration.
adapter (ref.: DB587), as shown in
the way when connecting to your application board with the DIP16/SO16 device
adapter.
Figure 6
.
ST7MDT10-DVP3 Probe User Guide
Figure 4
footprint
footprint
(0.15”)
(0.15”)
SO16
SO16
. The