ST7MDT10-TEB/DVP STMicroelectronics, ST7MDT10-TEB/DVP Datasheet - Page 16

• Manufacturer Part Number: ST7MDT10-TEB/DVP
• Description: KIT ADAPTERS ST7
• Manufacturer: STMicroelectronics

Specifications of ST7MDT10-TEB/DVP

• Accessory Type: Target Board
• For Use With/related Products: ST7MDT10-DVP3 Emulator
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Connecting to your application board
3.4
16/31
SO20 package
This procedure tells you how to connect the ST7MDT10-DVP3 emulator to your
application board when your target ST7 microcontroller is in an SO20 package.
1 Solder the connection pins to your application board. When soldering, insert the
2 Ensure that the emulator and your application board are powered off.
3 Connect the 34-pin flat cable to the J1 connector on the ST7MDT10-DVP3
4 Plug the other end of the 34-pin flat cable into J1 on the DIP20 adapter
two sets of connection pins into the device adapter. The device adapter will
serve as a support during soldering and will ensure the correct spacing and
alignment of the pins (see inset in
TEB, making certain to align the orientation guides as shown in
J2 connector on your TEB is not used in this configuration.
(ref.: DB586), as shown in
Figure 8: SO20 connection to application board
SO20 device adapter
Connection
pins
Figure 8
Figure 8
.
Application board
).
ST7MDT10-DVP3 Probe User Guide
SO20 device adapter
DIP20 adapter with
Orientation indicators
Figure 4
. The