EVAL-AD7689EDZ Analog Devices Inc, EVAL-AD7689EDZ Datasheet - Page 8

• Manufacturer Part Number: EVAL-AD7689EDZ
• Description: BOARD EVAL AD7689
• Manufacturer: Analog Devices Inc
• Series: PulSAR®r

Specifications of EVAL-AD7689EDZ

• Number Of Adc's: 1
• Number Of Bits: 16
• Sampling Rate (per Second): 250k
• Data Interface: Serial
• Inputs Per Adc: 8 Single Ended
• Input Range: ±VREF
• Power (typ) @ Conditions: 12.5mW @ 250kSPS, 5 V
• Voltage Supply Source: Single Supply
• Operating Temperature: -40°C ~ 85°C
• Utilized Ic / Part: AD7689
• Silicon Manufacturer: Analog Devices
• Application Sub Type: ADC
• Kit Application Type: Data Converter
• Silicon Core Number: AD7689
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

EVAL-AD76MUXEDZ
SOFTWARE OPERATION
The following details the operation of the software.
1. The arrow
2. The part to be evaluated is selected here.
3. The controls are used to set:
Sample Frequency – units can be used such as 500k (case
sensitive) for 500,000 Hz.
Capture Mode – This selects between continuous (Cont.) or
burst conversion modes. In continuous mode, the ADC is
continuously converting. In Burst mode, the ADC is not
converting (sample clock held in inactive state) and the
conversions begin once the “Single Capture” or “Continuous
Capture” buttons have been selected.
Interface mode – This selects the digital interface to the on-
board FPGA.
is displayed.
is used to start the software. When running
Figure 2. Setup Screen
Rev. PrD | Page 8 of 26
Input Range – this is used to adjust the LSB size in the data field
of the plot window.
4. These controls are used for saving, printing, help, etc. and are
also accessed in the File menu.
Save (F5): type – LabView config, allows the current
configuration to be saved to a filename.dat file. Useful when
changing many of the default controls. To load the saved
configuration, use the Load Previous Configuration. Note the
location of the .dat file. It is recommended to place into the
Support Files directory in the directory where the software was
installed.
Type – Html, saves the current screen shot to an Html file.
Type – Spreadsheet, saves the current data displayed in the chart
in a tab delimited spreadsheet. Raw ADC Data is time domain
in V or Code, FFT or Decimated is in dB.
5. Stop (F10) is used to stops the software. The
used to stop the software. RESET is used to reset the EVAL-
CED1Z.
Preliminary Technical Data
can also be
1
5
4
2
3