MCF5216CVM66J Freescale Semiconductor, MCF5216CVM66J Datasheet - Page 262

• Manufacturer Part Number: MCF5216CVM66J
• Description: IC MCU 512K FLASH 256MAPBGA
• Manufacturer: Freescale Semiconductor
• Series: MCF521xr

Specifications of MCF5216CVM66J

• Core Processor: Coldfire V2
• Core Size: 32-Bit
• Speed: 66MHz
• Connectivity: CAN, EBI/EMI, I²C, SPI, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 142
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 64K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-MAPBGA
• Processor Series: MCF521x
• Core: ColdFire V2
• 3rd Party Development Tools: JLINK-CF-BDM26, EWCF
• Development Tools By Supplier: M52210DEMO, M52211EVB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

Signal Descriptions
14.2.2.5 SDRAM Clock Enable (SCKE)
This output is the SDRAM clock enable.
This pin is configured as GPIO PSD0 in single-chip mode.
14.2.3
The clock and reset signals configure the device and provide interface signals to the external system.
14.2.3.1 Reset In (RSTI)
Asserting RSTI causes the device to enter reset exception processing. When RSTI is recognized the
address bus, data bus, SIZ, R/W, AS, and TS are three-stated. RSTO is asserted automatically when RSTI
is asserted.
14.2.3.2 Reset Out (RSTO)
After RSTI is asserted, the PLL temporarily loses its lock, during which time RSTO is asserted. When the
PLL regains its lock, RSTO negates again. This signal can be used to reset external devices.
14.2.3.3 EXTAL
This input is driven by an external clock except when used as a connection to the external crystal when
using the internal oscillator.
14.2.3.4 XTAL
This output is an internal oscillator connection to the external crystal.
14.2.3.5 Clock Output (CLKOUT)
The internal PLL generates CLKOUT. This output reflects the internal system clock.
14.2.4
14.2.4.1 RCON
If the external RCON signal is asserted, then various chip functions, including the reset configuration pin
functions after reset, are configured according to the levels driven onto the external data pins (see
Section 27.6, “Functional
on the external configuration pins to allow for module configuration.
14.2.4.2 CLKMOD[1:0]
The state of the CLKMOD[1:0] pins during reset determines the clock mode after reset.
14-22
Clock and Reset Signals
Chip Configuration Signals
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3
Description”). The internal configuration signals are driven to reflect the levels
Freescale Semiconductor