MC68HC908GR8CDW Freescale Semiconductor, MC68HC908GR8CDW Datasheet - Page 314

• Manufacturer Part Number: MC68HC908GR8CDW
• Description: IC MCU 8K FLASH 8MHZ 28-SOIC
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC68HC908GR8CDW

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SCI, SPI
• Peripherals: LVD, POR, PWM
• Number Of I /o: 17
• Program Memory Size: 7.5KB (7.5K x 8)
• Program Memory Type: FLASH
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 6x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 28-SOIC (7.5mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Serial Peripheral Interface (SPI)
20.9 Interrupts
Technical Data
314
NOTE:
slave. This happens because SS at logic 0 indicates the start of the
transmission (MISO driven out with the value of MSB) for CPHA = 0.
When CPHA = 1, a slave can be selected and then later unselected with
no transmission occurring. Therefore, MODF does not occur since a
transmission was never begun.
In a slave SPI (MSTR = 0), the MODF bit generates an SPI
receiver/error CPU interrupt request if the ERRIE bit is set. The MODF
bit does not clear the SPE bit or reset the SPI in any way. Software can
abort the SPI transmission by clearing the SPE bit of the slave.
A logic 1 voltage on the SS pin of a slave SPI puts the MISO pin in a high
impedance state. Also, the slave SPI ignores all incoming SPSCK
clocks, even if it was already in the middle of a transmission.
To clear the MODF flag, read the SPSCR with the MODF bit set and then
write to the SPCR register. This entire clearing mechanism must occur
with no MODF condition existing or else the flag is not cleared.
Four SPI status flags can be enabled to generate CPU interrupt
requests.
SPTE
SPRF
OVRF
MODF
Transmitter empty
Receiver full
Overflow
Mode fault
Freescale Semiconductor, Inc.
For More Information On This Product,
Flag
Serial Peripheral Interface (SPI)
Go to: www.freescale.com
Table 20-2. SPI Interrupts
SPI transmitter CPU interrupt request
SPI receiver CPU interrupt request
SPI receiver/error interrupt request (ERRIE = 1)
SPI receiver/error interrupt request (ERRIE = 1)
(DMAS = 0, SPTIE = 1, SPE = 1)
(DMAS = 0, SPRIE = 1)
Request
MC68HC908GR8 — Rev 4.0
MOTOROLA