DK-DEV-4CGX150N Altera, DK-DEV-4CGX150N Datasheet - Page 17

• Manufacturer Part Number: DK-DEV-4CGX150N
• Description: KIT STARTER CYCLONE IV GX
• Manufacturer: Altera
• Series: CYCLONE® IV GXr
• Type: FPGAr

Specifications of DK-DEV-4CGX150N

• Contents: Board, Cable, Documentation, Power Supply
• For Use With/related Products: Cyclone IV GX
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2713

Chapter 2: Board Components
Configuration, Status, and Setup Elements
Table 2–6. MAX II CPLD EPM2210 System Controller Component Reference and Manufacturing Information
Configuration, Status, and Setup Elements
Configuration
© March 2010 Altera Corporation
Board Reference
U10
IC - MAX II CPLD EPM2210
256FBGA -3 LF 2.5 V VCCINT
This section describes the board's configuration, status, and setup elements.
This section describes the FPGA, flash memory, and MAX II CPLD EPM2210 System
Controller device configuration methods supported by the Cyclone IV GX Transceiver
starter board. The Cyclone IV GX Transceiver starter board supports the following
configuration methods:
■
■
■
■
FPGA Configuration over Embedded USB-Blaster
The USB-Blaster is implemented using a USB Type-B connector (J5), a FTDI USB 2.0
PHY device (U5), and an Altera MAX II CPLD (U4). This allows the configuration of
the FPGA using a USB cable directly connected between the USB port on the board
(J5) and a USB port of a PC running the Quartus II software. The JTAG chain is
normally mastered by the embedded USB-Blaster found in the MAX II CPLD
EPM240M100.
The embedded USB-Blaster is automatically disabled when an external USB-Blaster is
connected to the JTAG chain.
Embedded USB-Blaster is the default method for configuring the FPGA at any
time using the Quartus II Programmer in JTAG mode with the supplied USB cable.
Flash memory download is used for storing FPGA images which the MAX II
CPLD EPM2210 System Controller uses to configure the Cyclone IV GX device
either on board power-up or after the PGM configure push-button switch (S8) is
pressed.
External USB-Blaster for configuring the FPGA using an external USB-Blaster.
Serial configuration (EPCS) device (U15) is used to store configuration data for
FPGA device that supports active serial (AS) configuration and reloads the data to
the FPGA upon power-up or reconfiguration.
Description
Altera Corporation
Manufacturer
Figure 2–4
illustrates the JTAG chain.
Cyclone IV GX Transceiver Starter Board Reference Manual
EPM2210F256C3N
Manufacturing
Part Number
www.altera.com
Manufacturer
Website
2–9