MC33696FCAE Freescale Semiconductor, MC33696FCAE Datasheet - Page 33

• Manufacturer Part Number: MC33696FCAE
• Description: IC UHF RECEIVER PLL TUNED 32-QFN
• Manufacturer: Freescale Semiconductor
• Type: Transceiverr

Specifications of MC33696FCAE

• Frequency: 304, 315, 426, 434, 868 & 915MHz
• Data Rate - Maximum: 20kbps
• Modulation Or Protocol: FSK, OOK
• Applications: General Data Transfer
• Power - Output: 7.5dBm
• Sensitivity: -106dBm
• Voltage - Supply: 2.7 V ~ 3.3 V, 4.5 V ~ 5.5 V
• Current - Receiving: 10.3mA
• Current - Transmitting: 13mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-QFN
• Operating Frequency: 915 MHz
• Operating Supply Voltage: 2.5 V or 3.3 V or 5 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 20 C
• Mounting Style: SMD/SMT
• Operating Temperature (min): -20C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Commercial
• Modulation Type: FSK/OOK
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

17.1.1 Direct Switch Control
The conditions to enter direct switch control are:
By simply writing BANKA and BANKB, the active bank will be defined:
The defined bank is active after exiting the configuration mode, in other words, CONFB line goes high.
The direct switch control should be used when:
17.1.2 Strobe Pin Switch Control
The conditions to enter strobe pin switch control are:
By simply writing BANKA and BANKB, the active banks will be defined.
The strobe pin will control the off/on state of the MC33696. The various available sequences are described
in the following subsections.
17.1.2.1 BANKA = X, BANKB = 0
If strobe pin is 1, configuration is defined by Bank A, BANKS = 1.
If strobe pin is 0, MC33696 configuration is OFF.
If a message is received during State A, current state remains State A up to end of message.
Freescale Semiconductor
Strobe Pin
State A
•
•
•
•
•
•
•
•
BANKA
BANKA
Strobe pin = V
SOE bit = 0
X
One or both banks are in transmitter configuration (MODE = 1)
When the strobe oscillator cannot be used to define the switch timing (for example, not periodic)
When strobe pin use is not possible (no sleep mode between the two configurations)
No automatic switching is required and MCU SPI access is possible
Strobe pin: controlled by MCU I/O port
SOE bit = 0
X
0
1
0
1
BANKB
BANKB
0
1
1
0
1
1
OFF
Bank A is active (TX or RX)
Bank B is active (TX or RX)
Not allowed in direct switch control
Bank A is active (TX or RX)
Bank B is active (TX or RX)
Bank A and Bank B are both active, configuration will toggle at each wakeup;
not allowed with MODE = 1
CC
MC33696 Data Sheet, Rev. 12
State A
OFF
Configuration Switching
33