C500CP131 Omron, C500CP131 Datasheet - Page 261

• Manufacturer Part Number: C500CP131
• Description: C-SERIES SPECIAL I/O UNIT
• Manufacturer: Omron

Specifications of C500CP131

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

machine code
machine language
main program
mark trace
masked bit
masking
Master
master
master number
MCR Unit
megabyte
memory area
memory card
memory switch
message number
mnemonic code
MONITOR mode
most-significant (bit/word)
MS-DOS
NC input
negative delay
nesting
Network Service Board
The binary program code that is actual executed by a CPU.
A programming language in which the program is written directly into machine
code.
All of a program except for subroutine and interrupt programs.
A process in which changes in the contents of specific memory locations are re-
corded during program execution using MARK (174) instructions.
A bit whose status has been temporarily made ineffective.
‘Covering’ an interrupt signal so that the interrupt is not effective until the mask is
removed.
Short for Remote I/O Master Unit.
In a SYSMAC NET Link System, a Unit specified to manage network communi-
cations.
A number assigned to a master in a SYSMAC NET Link System. This number is
different from the unit number.
Magnetic Card Reader Unit.
A unit of storage equal to one million bytes.
Any of the areas in the PC used to hold data or programs.
A data storage media similar to a floppy disk.
A bit or bits in memory that are used to set operating parameters similar to the
way a hardware switch would be.
A number assigned to a message generated with the MSG(195) instruction.
A form of a ladder-diagram program that consists of a sequential list of the in-
structions without using a ladder diagram.
A mode of PC operation in which normal program execution is possible, and
which allows modification of data held in memory. Used for monitoring or debug-
ging the PC.
See leftmost (bit/word).
An operating system in common use on smaller computers.
An input that is normally closed, i.e., the input signal is considered to be present
when the circuit connected to the input opens.
A delay set for a data trace in which recording data begins before the trace signal
by a specified amount.
Programming one loop within another loop, programming a call to a subroutine
within another subroutine, or programming an IF–ELSE programming section
within another IF–ELSE section.
A device with an interface to connect devices other than PCs to a SYSMAC NET
Link System.
Glossary
257