CRT1-ID16TAH Omron, CRT1-ID16TAH Datasheet - Page 88

• Manufacturer Part Number: CRT1-ID16TAH
• Description: 16 In NPN 3 Tier
• Manufacturer: Omron

Specifications of CRT1-ID16TAH

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Preparing Flat Connectors
64
1,2,3...
■ Attaching the Housing
■ Pressure-welding the Connector
■
Line Extensions and Terminating Resistors
2. Hold the cable and secure it with the hooks.
Insert the cable end all the way into a cover with the cable stopper already set.
Confirm that the cable labels and cable colors match and then temporarily
secure the housing to the cover.
The connector is pressure-welded using the DWT-A01 Pliers.
1. As shown below, align the center (see arrows) of the connector cover with
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
Housing
Pliers
Note The housing cannot be removed from the cover once it has been
the center of the pressure-welding block on the Pliers.
place.
attached. The connector may be damaged if the housing is force-
fully removed.
Connector cover
Location of cable stopper
Section 3-3