CRT1-ID16TAH Omron, CRT1-ID16TAH Datasheet - Page 90

• Manufacturer Part Number: CRT1-ID16TAH
• Description: 16 In NPN 3 Tier
• Manufacturer: Omron

Specifications of CRT1-ID16TAH

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Preparing Flat Connectors
66
1,2,3...
Note
■ Attaching the Cable
■ Crimping the Connector
Align the cable labels and cable colors and insert the cable.
Confirm that the cable is inserted all the way to the back. (The cover is semi-
transparent.)
Crimp the connector using the DWT-A01 Pliers.
1. As shown in the following figure, align the center (see arrows) of the con-
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
3. After attaching the cable, confirm that it is properly pressure-welded as
Pliers
(1) Do not pressure-weld the connector cover at the edges.
(2) Do not pressure-weld the connector cover at the back of the pressure-
(3) Set the connector in the correct orientation.
nector cover with the center of the crimping block on the Pliers.
place.
shown below.
welding block.
OK
NG
Be sure there are no gaps here.
Insert the cable to this point.
Connector cover
NG
NG
Section 3-3