CS4244-CNZ Cirrus Logic Inc, CS4244-CNZ Datasheet - Page 32

• Manufacturer Part Number: CS4244-CNZ
• Description: IC 4 Input / 5 Output CODEC
• Manufacturer: Cirrus Logic Inc

DS900PP2
4.6.1.2
In Left Justified or I²S mode, the CS4244 transmits the AIN1 and AIN2 signals on the SDOUT1 pin and
the AIN3 and AIN4 signals on the SDOUT2 pin.
In TDM mode, the
data for the DAC1-4 path is located within the incoming TDM streams. Details for this register and the bit
settings can be found in
In Left Justified or I²S mode, the CS4244 routes the data on the SDIN1 pin to DAC1 and DAC2 and the
data on the SDIN2 pin to DAC3 and DAC4.
Figure 20. Conventional SDOUT (Left) vs. Sidechain SDOUT (Right) Configuration
DSP
DAC1-4 Signal Routing
Note:
This diagram shows the configuration for 16 slot TDM streams. If 8 slot TDM streams are used, two separate serial data lines will need to be
connected from the DSP. One would carry the serial data for Devices C&D and the other would carry the serial data for Devices A&B
x
x
x
x
x
x
x
x
x
x
x
x
Device D
Device C
Device B
Device A
SDOUT1
SDIN2
SDIN1
SDOUT1
SDIN2
SDIN1
SDOUT1
SDIN2
SDIN1
SDOUT1
SDIN2
SDIN1
“DAC1-4 SOURCE[2:0]” bits in the "SP Data Sel." register
Figures 21
Each of the device’s ADC data
is reflected in the TDM stream
on SDOUT1 and then routed to
the system controller.
and 22.
DSP
x
x
x
x
x
x
x
x
x
x
x
x
Device D
Device C
Device B
Device A
SDOUT1
SDIN2
SDIN1
SDOUT1
SDIN2
SDIN1
SDOUT1
SDIN2
SDIN1
SDOUT1
SDIN2
SDIN1
The ADC data of Device D is coded into the
first four slots of the output TDM stream,
followed by the first 12 slots of the TDM
stream coming in on SDIN2, placing the
ADC data from Device C into slots 5-8, the
ADC data from Device B into slots 9-12, and
the ADC data from Device A into slots 13-16
of the outgoing TDM stream.
The ADC data of Device C is coded into the
first four slots of the output TDM stream,
followed by the first 12 slots of the TDM
stream coming in on SDIN2, placing the
ADC data from Device B into slots 5-8 and
the ADC data from Device A into slots 9-12
of the outgoing TDM stream.
The ADC data of Device B is coded into the
first four slots of the output TDM stream,
followed by the first 12 slots of the TDM
stream coming in on SDIN2, placing the
ADC data from Device A into slots 5-8 of the
outgoing TDM stream.
ADC data from Device A is loaded into the
first 4 slots of the 16 slot TDM Stream
going out of SDOUT1 pin of Device A. The
last 12 slots are all coded as “ 0's”.
advise the CS4244 where
CS4244
32