ZMOTIONL100ZCOG Zilog, ZMOTIONL100ZCOG Datasheet - Page 29

• Manufacturer Part Number: ZMOTIONL100ZCOG
• Description: EVALUATION KIT Z8FS040 ZMOTION
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONL100ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: 5m x 5m, 60 Degree Detection Pattern
• Interface: Serial
• Sensitivity: Adjustable
• Voltage - Supply: 5V
• Embedded: Yes
• Utilized Ic / Part: Z8FS040B
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-2511

UM023002-0112
Note:
At this point, you should have installed the FTDI to USB Serial Driver
and loaded ZDS II and the USB Smart Cable driver onto your computer. If
you haven’t yet done so, refer to the
Driver
Cable
1. Open ZDS II and select
2. Open the
3. Click the
project folder labeled
first receive your kit, this project is already loaded into the ZMOTION
MCU. Right-click within the open grey area below the menu icons and
select
and therefore make it easier to switch between files.
not indicate any errors. If you receive errors, try reloading the projects
from the original Application CD and ensure that the folders are not
set to
the location of the
section on page 18 for information about how to install these items.
section on page 23 and/or the
Read Only
Workbook Mode
Rebuild All
ZMOTION_Serial_Config.zdsproj
ZMOTION™ Detection and Control Development Kit
. See Figure 12 for an example; Figure 13 indicates
Rebuild All
icon to build the project. The build output should
ZMOTION_Serial_Config
Downloading and Running the Sample Project
File
to turn on the tabs at the bottom of the editor
→
icon in the ZDS II menu bar.
Open Project
Installing the FTDI USB to Serial
Installing ZDS II and the USB Smart
, then navigate to the
project. When you
.
User Manual
25