ZMOTIONL100ZCOG Zilog, ZMOTIONL100ZCOG Datasheet - Page 35

• Manufacturer Part Number: ZMOTIONL100ZCOG
• Description: EVALUATION KIT Z8FS040 ZMOTION
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONL100ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: 5m x 5m, 60 Degree Detection Pattern
• Interface: Serial
• Sensitivity: Adjustable
• Voltage - Supply: 5V
• Embedded: Yes
• Utilized Ic / Part: Z8FS040B
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-2511

UM023002-0112
Making Changes to the ZMOTION_Serial_Config
Project
0) Display API Registers.
Engine registers.
1) Read/Write RAM.
RAM locations (Peek/Poke).
2) MCU Reset.
3) LED On/Off Time.
mum LED OFF time.
4) Display Events On/Off.
ON or OFF. When OFF, events are still stored in the log.
5) Dump Event Log.
6) Reset Event Log/Counts.
stamp to 0.
7) Hypersense On Time.
when motion is detected, the sensitivity of the system can be increased for
a set amount of time;
detected while sensitivity is increased, the ON time starts over.
8) Hypersense Mode/Level.
tivity to motion during Hypersense; these settings are
tivity
you to enable and set each of these settings individually.
9) Normal Sense Level.
in Hypersense mode), this selection allows you to set the sensitivity levels
of the three settings (
Range
The operation of the motion detection software can be changed by making
modifications directly to the source code. Follow the comments in the
code (generally in
).
,
Minor Sensitivity
ZMOTION™ Detection and Control Development Kit
Reset the ZMOTION MCU.
main.h
Major Sensitivity
Allows you to make direct modifications to specific
Hypersense On Time
Displays a history of motion events since power-on.
Sets the duration of the LED ON time and mini-
When in
If Hypersense mode (menu item 8) is enabled
and
Downloading and Running the Sample Project
Displays the current setting of the ZMOTION
Turns the automatic display of motion events
There are three settings that control sensi-
Clears the Event Log and resets the time
main.c
and
Normal
Range
) to make any permanent changes.
motion sense mode (i.e., not
. This menu option allows
,
Minor Sensitivity
sets this time. If motion is
Major Sensi-
User Manual
and
31