MTCBA-H4-EN2-GP-P2 Multi-Tech Systems, MTCBA-H4-EN2-GP-P2 Datasheet - Page 76

• Manufacturer Part Number: MTCBA-H4-EN2-GP-P2
• Description: ROUTER WIRELESS QUAD HSPA
• Manufacturer: Multi-Tech Systems
• Series: MultiModem® rCellr

Specifications of MTCBA-H4-EN2-GP-P2

• Function: Transceiver, HSPA, Router
• Modulation Or Protocol: GPRS, GSM, EDGE
• Frequency: 850MHz, 900MHz, 1.8GHz, 1.9GHz, 1575.42MHz
• Applications: AT&T Networks (USA)
• Interface: RJ-45, RS-232
• Sensitivity: -161dB
• Voltage - Supply: 9 V ~ 32 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 881-1090

+CPMS Preferred Message Storage
High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A)
Description:
Syntax:
Values:
<bm>
<ds>
<bfr>
0
This command allows the message storage area to be selected (for reading, writing, etc).
The total storage area size is: 100 for “MT”. In the future when the RUIM is supported, the
size will vary dependent on the configuration of the SIM
Command syntax: AT+CPMS=<mem1>,<used>,<total>
<mem1>
2 or 3 New CBMs are routed directly to the TE using unsolicited result code (format
0
1
0
1
<used>
<total>
Command
AT+CPMS=?
Note: Display available message storage areas.
AT+CPMS?
Note: Display currently selected area information.
AT+CPMS=”BC”
Note: Select invalid message storage area.
AT+CPMS=”MT”
Note: Select NV message storage
“MT”
Sets the result code indication routing for received Cell Broadcast Messages.
Default is 0.
No CBM indications are routed to the TE. The CBMs are not stored.
matches that of +CBM: <oa>, [<alpha>,] <scts> [,<tooa>, <length>]
<CR><LF><data> (text mode)
Sets the routing for SMS-STATUS-REPORTs. Default is 0.
No SMS-STATUS-REPORTs are routed.
SMS-STATUS-REPORTs are routed using unsolicited code: +CDS: <fo>, <mr>,
[<ra>] , [<tora>], <scts>, <dt>, <st> (Text mode)
Since <mode> cannot be changed, this parameter is no longer used, but these
values are still accepted for legacy purposes. Default is 0.
TA buffer of unsolicited result codes defined within this command is flushed to the
TE when <mode> 1…3 is entered (OK response shall be given before flushing the
codes)
TA buffer of unsolicited result codes defined within this command is cleared when
<mode> 1…3 is entered.
Memory area to be used to list, read and delete messages. It can be:
SMS Mobile Terminated message storage in NV (default)
Each reported memory area includes information about current used & total
storage locations. When <mem1> is selected, all following +CMGL, +CMGR and
+CMGD commands are related to the type of SMS stored in this memory.
The number of used storage locations in the reported area.
The total number of available storage locations.
Chapter 3 – Supported GSM/WCDMA AT Commands
Possible Responses
+CPMS: (“MT”)
OK
+CPMS: “MT”,3,99
OK
+CMS ERROR: 302
+CPMS: 0,99
OK
card.
76