LAN9312-NU SMSC, LAN9312-NU Datasheet - Page 37

• Manufacturer Part Number: LAN9312-NU
• Description: Ethernet ICs Hi Per 2 Port 10/100 Ethernet Switch
• Manufacturer: SMSC
• Type: Two Port Managed Ethernet Switchr

Specifications of LAN9312-NU

• Ethernet Connection Type: 10 Base-T, 100 Base-TX
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Product: Ethernet Switches
• Number Of Transceivers: 1
• Standard Supported: 802.3, 802.3u
• Data Rate: 10 Mbps, 100 Mbps
• Supply Voltage (max): 3.3 V
• Supply Voltage (min): 0 V
• Supply Current (max): 185 mA, 295 mA
• Maximum Operating Temperature: + 70 C
• Package / Case: TQFP-100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface
Datasheet
SMSC LAN9312
4.2.1
RESET SOURCE
Digital Reset
Virtual PHY
Port 2 PHY
Port 1 PHY
Soft Reset
nRST Pin
Note 4.1
Chip-Level Resets
A chip-level reset event activates all internal resets, effectively resetting the entire LAN9312.
Configuration straps are latched, and the EEPROM Loader is run as a result of chip-level resets. A
chip-level reset is initiated by assertion of any of the following input events:
Chip-level reset completion/configuration can be determined by polling the READY bit of the
Configuration Register (HW_CFG)
When set, the READY bit indicates that the reset has completed and the device is ready to be
accessed.
With the exception of the
Register
(RESET_CTL), read access to any internal resources is forbidden while the READY bit is cleared.
Writes to any address are invalid until the READY bit is set.
Note: The LAN9312 must be read at least once after any chip-level reset to ensure that write
POR
Power-On Reset (POR)
nRST Pin Reset
operations function properly.
(PMT_CTRL),
In the case of a soft reset, the EEPROM Loader is run, but loads only the MAC address
into the Host MAC. No other values are loaded by the EEPROM Loader in this case.
X
X
X
Table 4.1 Reset Sources and Affected LAN9312 Circuitry
X
X
X
Byte Order Test Register
Hardware Configuration Register
X
X
X
or
DATASHEET
X
X
X
X
X
Power Management Control Register (PMT_CTRL)
37
X
X
X
X
X
X
X
X
(BYTE_TEST), and
(HW_CFG),
X
X
X
X
X
X
Power Management Control
Reset Control Register
X
X
X
Revision 1.7 (06-29-10)
X
X
until it is set.
Note 4.1
Hardware
X
X
X