66102 EATON POWERWARE/MGE OFFICE PROTECTION, 66102 Datasheet - Page 18

• Manufacturer Part Number: 66102
• Description: Network Management Card
• Manufacturer: EATON POWERWARE/MGE OFFICE PROTECTION

Specifications of 66102

• For Use With: Central UPS Systems That Protect A Complete Network Or For UPS Systems Providing Back-up For Critical Equipment

4.2.3 UPS control
Click on the "UPS Control" section in the menu
UPS configuration may prevent the shutdown and restart commands from being properly run. Read the UPS user manual for more
information.
This page enables triggering of
The Check column proposes six different commands, and a command is only actually started after clicking on 'Execute':
"Safe power down": A sequence to switch off output power is launched immediately. The systems supplied are shut down correctly while the
shutdown sequence is running, then the output is cut.
"Safe power down & reboot": A sequence to switch off then restore output power is launched immediately. The powered systems are shut
down correctly during the shutdown sequence, then the output is switched off.
Finally, the restart sequence is launched at the end of the time delay specified in the "Toggle duration" parameter. The output status is
updated.
T H E
Network Management Card – User Manual
The status of each output is displayed by a symbol associated with the Off label (red symbol) or On (green symbol).
The shutdown sequences take into account the time required for the registered servers to shut down without losing data
The main outlet has priority over the controlled outlets. Shutdown of the main outlet causes the controlled outlets to shut down. Controlled
parameters).
outlets can only be started if the master outlet is on.
U N I N T E R R U P T I B L E
startup and shutdown sequences
P O W E R
34003991EN/GA
for the UPS main output and controlled outlets.
P R O V I D E R
(see shutdown
- 18 -