9015 JEWELL / MODUTEC, 9015 Datasheet - Page 21

• Manufacturer Part Number: 9015
• Description: MULTIMETER DIGITAL HANDHELD, 3-1/2 DIGIT
• Manufacturer: JEWELL / MODUTEC

Specifications of 9015

• Dmm Type: Handheld
• Voltage Measuring Range Dc: 1000
• Voltage Measuring Range Ac: 750
• Current Measuring Range Dc: 2mA To 10A
• Current Measuring Range Ac: 20mA To 10A
• Lead Free Status / RoHS Status: na

7.11 Measuring Temperature:
7.11.1 Remove the test leads from the input jacks of the meter.
7.11.2 Set the RANGE switch to the TEMP
7.11.3 Read temperature from LCD display.
7.12 Measuring Capacitance:
7.12.1 Remove test leads from the input jacks of the meter. The test leads
7.12.2 Set the RANGE switch to the appropriate Capacitance (
7.12.3 Insert the capacitor to be measured into the Cx socket.
7.12.4 If the display indicates overrange, i.e. “1- - -”, rotate the RANGE
7.12.5 If the displayed value is less than “200” (decimal point not shown), a
Do not connect a charged capacitor to the Cx socket of the meter.
Do not attempt to measure the temperature of any surface that is
Observe proper polarity.
more accurate reading may be obtained by setting the RANGE switch
(i.e. 20uF), the capacitance exceeds the value measurable by the meter.
thermocouple into the jack on the front of the meter.
cannot be used to measure capacitance and may pose a safety hazard if
left connected.
switch to the next higher position and observe the reading on the LCD
display. If the RANGE switch is already at the highest position
to a lower range. Rotate the RANGE switch to the next lower position
and observe the reading on the LCD display. If the RANGE switch is
already on the lowest position (i.e. 2nF), no greater measurement
resolution can be obtained.
electrically “live”. Failure to observe this precaution
Doing so may damage the meter or injure the user.
may result in injury to the user.
WARNING!!!
WARNING!!!
20
°
F position. Plug the provided K-type
) range.