85134F AGILENT TECHNOLOGIES, 85134F Datasheet - Page 19

• Manufacturer Part Number: 85134F
• Description: Cable Sets
• Manufacturer: AGILENT TECHNOLOGIES

Specifications of 85134F

• Kit Contents: 2 Cables
• Peak Reflow Compatible (260 C): No
• Cable Length: 24.75"
• Leaded Process Compatible: No
• Connector Type B: 3.5mm Female
• Connector Type A: 2.4mm Female
• Lead Length: 62.9cm
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Cleaning Connectors
Clean connectors are essential for ensuring the integrity of RF and microwave coaxial
connections.
1. Use Compressed Air or Nitrogen
WARNING
2. Clean the Connector Threads
WARNING
Use isopropyl alcohol with adequate ventilation and avoid contact with eyes,
skin, and clothing. It causes skin irritation, may cause eye damage, and is
harmful if swallowed or inhaled. It may be harmful if absorbed through the skin.
Wash thoroughly after handling.
In case of spill, soak up with sand or earth. Flush spill area with water.
85134E/F/H & 85135E/F
Use compressed air (or nitrogen) to loosen particles on the connector mating plane
surfaces.
You can use any source of clean, dry, low-pressure compressed air or nitrogen that has
an effective oil-vapor filter and liquid condensation trap placed just before the outlet
hose.
Ground the hose nozzle to prevent electrostatic discharge, and set the air pressure to
less than 414 kPa (60 psi) to control the velocity of the air stream. High-velocity
streams of compressed air can cause electrostatic effects when directed into a connector.
These electrostatic effects can damage the device. Refer to
earlier in this chapter for additional information.
Use a lint-free swab or cleaning cloth moistened with isopropyl alcohol to remove any
dirt or stubborn contaminants on a connector that cannot be removed with compressed
air or nitrogen. Refer to
cleaning swabs.
a. Apply a small amount of isopropyl alcohol to a lint-free cleaning swab.
b. Clean the connector threads.
c. Let the alcohol evaporate, then blow the threads dry with a gentle stream of clean,
low-pressure compressed air or nitrogen. Always completely dry a connector before
Dispose of isopropyl alcohol in accordance with all applicable federal,
state, and local environmental regulations.
Always use protective eyewear when using compressed air or
nitrogen.
Keep isopropyl alcohol away from heat, sparks, and flame. Store in a
tightly closed container. It is extremely flammable. In case of fire, use
alcohol foam, dry chemical, or carbon dioxide; water may be
ineffective.
Table 4-1 on page 4-4
for part numbers for isopropyl alcohol and
Use, Maintenance, and Care of the Cables
“Electrostatic Discharge”
Cleaning Connectors
3-5