85134F AGILENT TECHNOLOGIES, 85134F Datasheet - Page 30

• Manufacturer Part Number: 85134F
• Description: Cable Sets
• Manufacturer: AGILENT TECHNOLOGIES

Specifications of 85134F

• Kit Contents: 2 Cables
• Peak Reflow Compatible (260 C): No
• Cable Length: 24.75"
• Leaded Process Compatible: No
• Connector Type B: 3.5mm Female
• Connector Type A: 2.4mm Female
• Lead Length: 62.9cm
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Use, Maintenance, and Care of the Cables
Handling and Storage
connector to be sure it will not damage the 3.5 mm connector. Use only a 90 N-cm (8 in-lb)
torque wrench on any connection involving an SMA connector.
How to Separate a Connection
To avoid lateral (bending) force on the connector mating plane surfaces, always support the
devices and connections.
CAUTION
1. Use an open-end wrench to prevent the device body from turning.
2. Use the torque wrench to loosen the connecting nut.
3. Complete the separation by hand, turning only the connecting nut.
4. Pull the connectors straight apart without twisting, rocking, or bending either of the
Handling and Storage
• Install the protective end caps and store the cables in the foam-lined storage case when
• Never store cables loose in a box, desk, or bench drawer. This is the most common cause
• Store cables in the same shape they have when you use them; do not either straighten a
• Keep cable connectors clean.
• Do not touch connector mating plane surfaces. Natural skin oils and microscopic
• Do not set cable connectors contact-end down on a hard surface. The plating and the
Avoiding Cable Movement
When you use cables to make a precise calibration, you may have to fixture the cables to
prevent excessive movement after the calibration. In some cases, unless you restrict cable
movement, you may not be able to perform a verification after the calibration, especially if
you use a precision calibration kit.
3-16
connectors.
not in use.
of cable connector damage during storage.
cable or flex it more tightly. Even flexible cables last longer if you flex them as little as
possible.
particles of dirt are easily transferred to a connector interface and are very difficult to
remove.
mating plane surfaces can be damaged if the interface comes in contact with any hard
surface.
Do not turn the device body. Only turn the connector nut. Damage to the
center conductor can occur if the device body is twisted.
85134E/F/H & 85135E/F