LAN9220-ABZJ Standard Microsystems (SMSC), LAN9220-ABZJ Datasheet - Page 100

• Manufacturer Part Number: LAN9220-ABZJ
• Description: 10/100 NON-PCI ETHERNET CONTROLLER
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LAN9220-ABZJ

• Operating Supply Voltage (typ): 1.8/3.3V
• Operating Supply Voltage (max): 3.6V
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 56
• Lead Free Status / RoHS Status: Compliant

Revision 2.7 (03-15-10)
5.3.22
31:24
23:16
BITS
15:8
7:4
3
2
1
Reserved
Automatic Flow Control High Level (AFC_HI). Specifies, in multiples of
64 bytes, the level at which flow control will trigger. When this limit is
reached the chip will apply back pressure or will transmit a pause frame as
programmed in bits [3:0] of this register.
During full-duplex operation only a single pause frame is transmitted when
this level is reached. The pause time transmitted in this frame is
programmed in the FCPT field of the FLOW register in the MAC CSR space.
During half-duplex operation each incoming frame that matches the criteria
in bits [3:0] of this register will be jammed for the period set in the
BACK_DUR field.
Automatic Flow Control Low Level (AFC_LO). Specifies, in multiples of
64 bytes, the level at which a pause frame is transmitted with a pause time
setting of zero. When the amount of data in the RX data FIFO falls below
this level the pause frame is transmitted. A pause time value of zero
instructs the other transmitting device to immediately resume transmission.
The zero time pause frame will only be transmitted if the RX data FIFO had
reached the AFC_HI level and a pause frame was sent. A zero pause time
frame is sent whenever automatic flow control in enabled in bits [3:0] of this
register.
Note:
Backpressure Duration (BACK_DUR). When the LAN9220 automatically
asserts back pressure, it will be asserted for this period of time. This field
has no function and is not used in full-duplex mode. Please refer to
Table
information.
Flow Control on Multicast Frame (FCMULT). When this bit is set, the
LAN9220 will assert back pressure when the AFC level is reached and a
multicast frame is received. This field has no function in full-duplex mode.
Flow Control on Broadcast Frame (FCBRD). When this bit is set, the
LAN9220 will assert back pressure when the AFC level is reached and a
broadcast frame is received. This field has no function in full-duplex mode.
Flow Control on Address Decode (FCADD). When this bit is set, the
LAN9220 will assert back pressure when the AFC level is reached and a
frame addressed to the LAN9220 is received. This field has no function in
full-duplex mode.
AFC_CFG – Automatic Flow Control Configuration Register
This register configures the mechanism that controls both the automatic, and software-initiated
transmission of pause frames and back pressure.
Note: The LAN9220 will not transmit pause frames or assert back pressure if the transmitter is
5.5, describing Backpressure Duration bit mapping for more
Offset:
When automatic flow control is enabled the AFC_LO setting must
always be less than the AFC_HI setting.
disabled.
DESCRIPTION
16-bit Non-PCI Small Form Factor 10/100 Ethernet Controller with Variable Voltage I/O & HP Auto-MDIX Support
ACh
DATASHEET
100
Size:
32 bits
TYPE
R/W
R/W
R/W
R/W
R/W
R/W
RO
DEFAULT
SMSC LAN9220
00h
00h
Datasheet
0h
0
0
0
-