MT29F8G08ABABAWP:B Micron Technology Inc, MT29F8G08ABABAWP:B Datasheet - Page 52
![no-image](/images/manufacturer_photos/0/4/441/micron_technology_inc_sml.jpg)
MT29F8G08ABABAWP:B
Manufacturer Part Number
MT29F8G08ABABAWP:B
Description
Manufacturer
Micron Technology Inc
Datasheet
1.MT29F8G08ABABAWPB.pdf
(142 pages)
Specifications of MT29F8G08ABABAWP:B
Lead Free Status / RoHS Status
Supplier Unconfirmed
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
MT29F8G08ABABAWP:B
Manufacturer:
SPANSION
Quantity:
4 310
Company:
Part Number:
MT29F8G08ABABAWP:B
Manufacturer:
MICRON
Quantity:
11 200
Part Number:
MT29F8G08ABABAWP:B
Manufacturer:
MICRON/美光
Quantity:
20 000
Configuration Operations
Table 9:
SET FEATURES EFh
PDF: 09005aef8386131b / Source: 09005aef838cad98
m61a_async_sync_nand.fm - Rev. A 2/09 EN
Feature Address Definitions
The GET FEATURES (EEh) and SET FEATURES (EFh) commands are used to modify the
target's default power-on behavior. These commands use a one-byte feature address to
determine which sub-feature parameters will be read or modified. Each feature address
(in the 00h to FFh range) is defined in Table 9. The GET FEATURES command reads the
sub-feature parameters (P1-P4) at the specified feature address. The SET FEATURES
(EFh) command writes sub-feature parameters (P1-P4) to the specified feature address.
The SET FEATURES (EFh) command writes the sub-feature parameters (P1-P4) to the
specified feature address to enable or disable target-specific features. This command is
accepted by the target only when all LUNs on the target are idle.
Writing EFh to the command register puts the target in the set features mode. The target
stays in this mode until another command is issued.
The EFh command is followed by a valid feature address as specified in Table 9 on
page 52. The host waits for
asynchronous interface is active, one sub-feature parameter is latched per rising edge of
WE#. When the synchronous interface is active, one sub-feature parameter is latched
per rising edge of DQS. The data on the falling edge of DQS should be identical to the
sub-feature parameter input on the previous rising edge of DQS.
After all four sub-feature parameters are input, the target goes busy for
STATUS (70h) command can be used to monitor for command completion.
Feature address 01h (timing mode) operation is unique. If SET FEATURES is used to
modify the interface type, the target will be busy for
page 37 for details.
Feature Address Definition
00h
01h
02h–0Fh
10h
11h–7Fh
80h
81h
82h–8Fh
90h
91h–FFh
Micron Confidential and Proprietary
Reserved
Programmable output drive strength
Reserved
Programmable output drive strength
Reserved
Reserved
Reserved
Timing mode
Programmable RB# pull-down strength
Array operation mode
8Gb Asychronous/Synchronous NAND Flash Memory
t
ADL before the sub-feature parameters are input. When the
52
Micron Technology, Inc., reserves the right to change products or specifications without notice.
t
ITC. See “Activating Interfaces” on
Command Definitions
©2008 Micron Technology, Inc. All rights reserved.
t
FEAT. The READ
Advance