SU2200RMXLTNET APC, SU2200RMXLTNET Datasheet - Page 40

• Manufacturer Part Number: SU2200RMXLTNET
• Description: UPS - Uninterruptible Power Supplies APC Smart-UPS XL 2200VA RM 5U 208V
• Manufacturer: APC

Specifications of SU2200RMXLTNET

• Power Rating: 1600 W
• Output Voltage Rating: 208 V
• Number Of Outlets: 5
• Interface Port: DB-9 RS-232, SmartSlot
• Runtime (full Load): 10 min
• Runtime (half Load): 34 min
• Topology: Online
• Tower / Rackmount: Rackmount
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

7. Disconnect the two wires from the rear of the circuit breaker on
8. Discard the output panel and the 4 screws.
Remove the Input Panel
NOTE:
1. Remove the two screws from the input panel as shown in Figure 5-
2. Unplug the 4-pin input connector
3. Discard the input panel, cord, and screws.
5.4.2 Installing the Wire Harness Assembly
NOTE:
38
the output panel. Working from the front side of the output panel,
use a small screwdriver to apply pressure to the side of the circuit
breaker and push it free of the panel. Save the circuit breaker for
reinstallation into the new output panel.
25.
cation of the input connection.
If you are hard wiring only the output, skip this section and
continue with Section 5.4.2.
If you are hard wiring the input only, retrieve the old line
cord and cut the last 6” from the end with the 4-wire con-
nector attached. This connector and the attached wires will
be spliced to your input line. Using approved field-applied
splicing devices, connect the two black wires to Line1 (or
Hot) of your input line and the two white wires to Line2 (or
Neutral) of your input line. Plug the connector into the mat-
ing connector in the UPS (Figure 5-25) and reinstall the in-
put and output panels.
as shown below. Note the lo-