SU2200RMXLTNET APC, SU2200RMXLTNET Datasheet - Page 45

• Manufacturer Part Number: SU2200RMXLTNET
• Description: UPS - Uninterruptible Power Supplies APC Smart-UPS XL 2200VA RM 5U 208V
• Manufacturer: APC

Specifications of SU2200RMXLTNET

• Power Rating: 1600 W
• Output Voltage Rating: 208 V
• Number Of Outlets: 5
• Interface Port: DB-9 RS-232, SmartSlot
• Runtime (full Load): 10 min
• Runtime (half Load): 34 min
• Topology: Online
• Tower / Rackmount: Rackmount
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

5.4.4 Installation of New Rear Panels
Before closing up the back of the unit, make sure that all wiring has
been properly installed:
1. Auxiliary output wiring (120V) is connected to the first two screw
2. Output wiring (208V) is connected to the center two screw termi-
3. Input wiring is connected to the last two screw terminals at the
Make sure all ground wires (green) are securely fastened to an appro-
priate ground screw.
Install the Output Panel
1. Slide the output panel into position as shown in Figure 5-29. In-
2. Make sure there are a few inches of slack output cable tucked in-
3. Tighten the cable clamp. The clamp will prevent strain on the con-
Install the Input Panel
1. Slide the input panel into position as shown in Figure 5-29. Fasten
2. Make sure there are a few inches of slack input cable tucked inside
3. Tighten the cable clamp. The clamp will prevent strain on the con-
terminals at the left of the terminal block.
nals of the terminal block.
right of the terminal block.
stall the circuit breaker by pushing it through the hole in the out-
put panel until it snaps into place. Fasten the panel to the UPS
with two self-locking panel screws from the hardware bag.
side the unit.
nections if the output cable is accidentally pulled.
the panel into position as shown. Fasten the panel to the UPS with
two self-locking panel screws from the hardware bag.
the unit.
nections if the input cable is accidentally pulled.
43