PEF24911HV22XP Lantiq, PEF24911HV22XP Datasheet - Page 79
![](/photos/31/31/313132/64pin_mqfp_sml.jpg)
PEF24911HV22XP
Manufacturer Part Number
PEF24911HV22XP
Description
Manufacturer
Lantiq
Datasheet
1.PEF24911HV22XP.pdf
(155 pages)
Specifications of PEF24911HV22XP
Control Interface
HDLC
Lead Free Status / Rohs Status
Supplier Unconfirmed
- Current page: 79 of 155
- Download datasheet (3Mb)
4
The scope of this section is to describe how the DFE-Q V2.1 works and behaves in the
system environment. Activation/ deactivation control procedures are exemplary given for
SW programmers reference.
4.1
There are two different ways to apply a reset,
• either as a hardware reset by setting pin RES to low
• or as a software reset by applying ’C/I= RES’
Hardware Reset
A hardware reset affects all design components and takes effect immediately
(asynchronous reset style). No clock signal other than the 15.36 MHz master clock is
required for reset execution.
Software Reset
C/I ’RES’ resets the receiver and the activation/deactivation state machine.
Transmission on U is stopped. It is an unconditional command and is therefore
applicable in any state.
Unlike a hardware reset, a software reset triggered by ’C/I= RES’ or ’C/I= RES1’ has only
effect on the addressed line port.
– C/I= RES resets the receiver and the activation/deactivation state machines. It is an
– C/I= RES1 resets all receiver functions. Transmission on U is stopped. EC-, and EQ-
The remaining line ports, the system interface, the relay driver/ status pins and other
global functions are not affected. Note that FSC and DCL clock signals must be provided
for the C/I code processing.
4.2
Each building block of the DFE-Q V2.1 is optimized with respect to power consumption
and support a power down mode. See
power consumption.
The DFE-Q V2.1 goes in power down mode if the U-transceiver is in state
DEACTIVATED. The DFE-Q V2.1 leaves power down mode when a wake up tone (TN)
has been detected on the U-interface for at least 800 µs.
• as the internal control logic of the activation/deactivation procedures are event driven
Data Sheet
unconditional command.
coefficients and AGC are set to zero. It is a conditional command.
power is saved as soon as one of the four lines transits in the ’Deactivated’ state
Operational Description
Reset
Power Down
Chapter 7.6.2
69
on
Page 139
Operational Description
for the specified max.
PEF 24911
2001-07-16
Related parts for PEF24911HV22XP
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![PEB22811H-V13X](/images/manufacturer_photos/0/3/379/lantiq_tmb.jpg)
Part Number:
Description:
Manufacturer:
Lantiq
Datasheet:
![ADM6996L-AA-T-1](/images/manufacturer_photos/0/3/379/lantiq_tmb.jpg)
Part Number:
Description:
Manufacturer:
Lantiq
Datasheet:
![PEF22810T-V21TR](/images/manufacturer_photos/0/3/379/lantiq_tmb.jpg)
Part Number:
Description:
Manufacturer:
Lantiq
Datasheet: